What did you do to/for your EZGO today?

[DriftingAnomaly]

Originally Posted by SpoiledRotten

Just got done scrolling through the old thread. Been a few years since this one was started. Lots of things have happened since then. You guys have got some great looking carts. Proud for you. Hoping to see many more come through here. God bless.

It's been more than a few years. My cart is much more modest than the carts that I have seen on here. It is still fun for the family though. Thanks for making this thread all of those years ago. It is a nice place to celebrate the little improvements that don't deserve a whole thread.

[GolfNfool]

Hard mounted the FNR switch and 175 amp Anderson charger mount. 3D printed from some guy in Australia. Very solid work.

[GolfNfool]

Yeti cup holder and dashboard for toggles finally finished

[DaveTM]

Originally Posted by GolfNfool

Yeti cup holder and dashboard for toggles finally finished

Very nice. I need a Yeti adapter to fit in the standard car cup holder and thus allow my Yeti cup to not fly off the console.

[DriftingAnomaly]

I installed a SuP mount on the side for my wife. I found a model that swivels out of the way when not in use.

[GolfNfool]

Originally Posted by DaveTM

Very nice. I need a Yeti adapter to fit in the standard car cup holder and thus allow my Yeti cup to not fly off the console.

Thanks. Got tired of holding it between my legs. Now I've got to find a decent toggle panel.

[GolfNfool]

Finally shortened the Precedent IQ wire harness and removed leads that weren't used. Before and after attached.

[five5cooks]

Drew and laser cut a new key panel. I This was my test cut, and I will probably cut the final panel with some accents to match the end cart color.

[GolfNfool]

Originally Posted by five5cooks

Drew and laser cut a new key panel. I This was my test cut, and I will probably cut the final panel with some accents to match the end cart color.

What are you using for your laser cutter? Could have used something like that for my cup holder.

[five5cooks]

I have a couple of Lasers. This one was on my OMTECH with a 60W CO2 laser. I need to tweak the sizes to tighten up the light switch just a touch. I am also going to probably do some orange highlights on the final version. Considering how much they want for the metal version, I thought this was a nicer way to do this.