|
Gas EZGO Gas EZGO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
10-21-2012, 11:18 PM | #1 |
Not Yet Wild
Join Date: Oct 2012
Location: Woodstock, GA
Posts: 12
|
hei conversion ? for 91 marathon
I'm a little stumped... Working on converting my 91 marathon to HEI, but I have come to find that the colors of the wiring in the diagram in the sticky thread differ from my cart. Also, correct me if I'm wrong, are we bypassing the use of the voltage regulator with this mod? Or are the "solenoid" wires in the diagram meant to be coming from the regulator? Either way, it's not adding up after a couple hours of deliberation now. Any help would be great.
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
10-22-2012, 07:49 AM | #2 |
Gone Wild
Join Date: Feb 2011
Posts: 1,515
|
Re: hei conversion ? for 91 marathon
Diesel Welcome to BGW Don't worry about wire colors just follow the diagram and add your wires. No your not doing anything to the regulator except adding a ground wire to the - terminal of the regulator posted. As for the pulser wires if they are a different color don't be concerned ether way as you may have to reverse them on the module for it to run proper. A tip make sure the module is mounted to a clean surface and cut the 2 small tab off of the backside of the module so it will sit flat on the surface. Look at the module and you'll see a grounding tab in one of the bolt holes be sure to put a ground wire on this bolt or screw and you can go straight to frame ground this is important to be grounded.
LOU |
10-22-2012, 11:06 AM | #3 |
Not Yet Wild
Join Date: Oct 2012
Location: Woodstock, GA
Posts: 12
|
Re: hei conversion ? for 91 marathon
Thanks for the input, I was finally able to figure it out once I labeled my solenoid. I used the factory wiring that was already there for my quote-unquote red/yellow and green wire . She runs great now. My module didn't have any extra ground tab, just brass eyelets in the mounting holes. It is mounted directly to the frame on the flat surface below the voltage regulator.
|
10-23-2012, 07:22 AM | #4 |
Gone Wild
Join Date: Feb 2011
Posts: 1,515
|
Re: hei conversion ? for 91 marathon
Good you have it going. If you were to look closely at the two eyelets you will see a small strap on one of them I just mentioned it because adding a ground wire to it is just security ok. I like redundancy.
LOU |
10-23-2012, 03:04 PM | #5 |
Not Yet Wild
Join Date: Oct 2012
Location: Woodstock, GA
Posts: 12
|
Re: hei conversion ? for 91 marathon
Thanks, Lou
|
|
Thread Tools | |
Display Modes | |
|
Similar Threads | ||||
Thread | Forum | |||
Ez go marathon back seat conversion | Gas EZGO | |||
ez go marathon with newer style top conversion. | Gas EZGO | |||
Conversion of Marathon to controller | Electric EZGO | |||
Marathon 48 volt conversion | Electric EZGO | |||
marathon 48v conversion | Electric EZGO |