03-18-2014, 12:28 PM | #1 |
Not Yet Wild
Join Date: Apr 2012
Location: Uniontown PA
Posts: 47
|
setting valve lash
Ok, so I replaced the stock valve springs with the #35 springs. I was reading that when setting valve lash I should be about 1/4 inch piston travel after tdc of compression stroke to allow for the compression release mechanism. Can anyone elaborate?
Thanks |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
03-18-2014, 02:03 PM | #2 |
Gone Wild
Join Date: Sep 2011
Location: ARIZONA
Posts: 476
|
Re: setting valve lash
Set them at TDC when both are fully closed.
|
|
|
Similar Threads | ||||
Thread | Forum | |||
valve lash setting | Clone Engine Swaps | |||
Valve lash | Gas Yamaha | |||
Valve lash | Clone Engine Swaps | |||
Valve Lash | Gas Club Car | |||
Valve Lash | Gas Club Car |