|
09-02-2019, 11:17 AM
|
#1 |
|
Getting Wild
Join Date: Feb 2011
Location: Ohio
Posts: 96
|
Clutch falling off
Hey guys I have a 86 ezgo 2 stroke golf cart and I noticed my clutch is almost falling off and curious on how I take the clutch cover off to tighten it up ?
|
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
09-02-2019, 11:26 AM
|
#2 |
|
Test before replacing
Join Date: Aug 2013
Location: Ohio side of the Pennsylvania border.
Posts: 3,495
|
Re: Clutch falling off
I'm going to assume that you mean the driven clutch. There are about three small screws holding the cover on. The center bolt that holds the clutch on is located between #7, and #1 in the pdf.
|
|
|
|
|
09-03-2019, 02:43 PM
|
#3 |
|
Getting Wild
Join Date: Feb 2011
Location: Ohio
Posts: 96
|
Re: Clutch falling off
Thanks, I took the 3 bolts out around the cover and the larger bolt in the middle of the clutch cover, I tapped the cover off and was spring loaded ???
But my problem is that it feels loose and once I come to a stop most of the time I can here the clutch still spinning ?? |
|
|
|
|
09-03-2019, 02:44 PM
|
#4 |
|
Getting Wild
Join Date: Feb 2011
Location: Ohio
Posts: 96
|
Re: Clutch falling off
And the clutch is about 3-4 inches away from the engine is that normal
|
|
|
|
|
09-03-2019, 05:12 PM
|
#5 |
|
Test before replacing
Join Date: Aug 2013
Location: Ohio side of the Pennsylvania border.
Posts: 3,495
|
Re: Clutch falling off
The center bolt in the dust cover is a button for the governor lever to ride on. The center bolt under the cover is what holds the clutch on. The clutch mounts to a straight splined shaft. Neither the cover, nor the clutch bolt are spring loaded.
There is a snap ring that holds the clutch together under spring tension. If you feel anything that is spring loaded while the clutch is still mounted, I would say there is an issue with that snap ring. You should be able to remove the center bolt, and have room to slide the clutch off of the splined shaft with no problem. |
|
|
|
 |
|
||||||
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| G1 Secondary clutch falling off... again! | Gas Yamaha | |||
| clutch falling off | Gas EZGO | |||
| G2 Clutch Falling Off | Gas Yamaha | |||
| Axle keeps falling out | Electric EZGO | |||
| my snubber keeps falling off | Gas Club Car | |||
Linear Mode
