Looking for an electrical schematic for Gas EZGO

[CP241]

Originally Posted by Troy9567

What do you use for the Ignition Kill Relay?

Thanks

Any generic SPDT relay (single pole, double throw). Fog light relay. You should be able to get one for a buck or two at pretty much any auto parts store.

It is wired there for normally closed between 87A and 30. So when the pedal is up, the relay is NOT energized and it will allow ground to flow through to the kill wire and shut off the engine. When you press the pedal, it pushes the switch, sending power to the relay, which engergizes the coil and takes the contact away from 87A, and connects 87 to 30. Since 87 is not connected to anything, there's no ground to flow to the kill relay. As soon as you let off the pedal, it goes back to rest (87A and 30) thus grounding the coil and killing the engine

oreilly is expensive IMO at $6.50 each... amazon has these https://www.amazon.com/Dorman-88069-...648270&sr=8-18

[raydhd]

Sho305 has a sticky for this in the clone section.

[CP241]

Originally Posted by raydhd

Sho305 has a sticky for this in the clone section.

Thanks for contributing

[raydhd]

Along this line when I bought my VC 460 in 2014 I searched the web on how to wire a clone engine into a golf cart I found Sho's write up here on BGW. 2 birds with one search.

[Troy9567]

Thanks for everyone help, I got the golf cart running pretty good and it shuts off like it it supposed too this weekend. I did visit SHO write on clone wiring too and it helped.

Thanks again for your guys help. I'm definitely be asking more questions here (or looking them up) instead of beating my head against a wall. LOL