|
Electric Club Car Electric DS, and Precedent golf cars |
|
Thread Tools | Display Modes |
07-21-2019, 03:43 PM | #1 |
Gone Wild
Join Date: Dec 2013
Location: Mississippi
Posts: 216
|
Heim Joint Replacement Madjax 6" Heavy Duty Lift Kit
Had a ball joint break completely out of the heim joint last week on a club car precedent using a madjax 6" Heavy Duty Lift Kit
The Chromoly heim joints seem to be the way to go for a good long lasting replacement. Going to go ahead and replace both bottom heim joints on each side for good measure and want two new jam nuts. The stock Heim joint on a madjax 6" HD is 5/8 - however, I'm not certain on the correct size replacement of the ball joint hole diameter. I believe the regular madjax 6" lift kit can use the: American Star 4130 Chromoly 1/2 Inch XMR8 Rod Ends/Heim Joints - uses a /2-20 SAE Thread Pitch with 1/2 Inch with a (.500) Hole So since this is the HD lift kit using 5/8 heim joints .. is the hole diameter for the inner ball race still be the same at .500? or would it use a bigger BALL WIDTH: .625 Anyone that can point in the right direction? Much appreciated. |
Tags |
club car, heim joint, lift kit, madjax, precedent |
|
|
Similar Threads | ||||
Thread | Forum | |||
Heim Joint Replacement Madjax 6" Heavy Duty Lift Kit | Electric golf carts | |||
Adjusting Camber / Heim Joints MAdjax 6" lift | Electric Club Car | |||
Guidance needed for Madjax 6" lift install with heavy duty rear springs | Electric Club Car | |||
Need heim joint tie rods help | Lifted Golf Carts | |||
Question about heim joint - Jakes Lift Kit 4" A-Arm | Lifted Golf Carts |