|
Gas Yamaha Gas Yamaha Golf Cars; G1 through "The Drive" and U-Max Utility Vehicles |
|
Thread Tools | Display Modes |
03-05-2020, 08:04 PM | #21 |
VC 460 CLONE GONE WILD
Join Date: Oct 2014
Location: Ray BY The Bay NJ
Posts: 10,639
|
Re: 99 G16 not firing, clutch spinning
All kinds of options for a Yamaha G 16. I cannot think of any other cart that has as many repower choices as it does.
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
03-08-2020, 02:22 AM | #22 |
Not Yet Wild
Join Date: Jun 2019
Posts: 4
|
Re: 99 G16 not firing, clutch spinning
So what your saying is you press the throttle and had to crawl home? It turned the engine but barely made it and never fully kicked in spinning the belts? Before you rip apart the motor and all that jazz I'd check the Throttle cable. The one that comes off the pedal going into the motor. Lift the back end of the cart so the back wheels are off and try to use just the connection on the motor where that cable connects. If it engages then its the cable. I replaced mine and accidently ran it under the frame when I installed it instead of over it...I hit a rock and pinched the cable and had to slowly limp it home. Hopefully that's all it is because $40 is a lot cheaper than a new motor.
|
|
|
Similar Threads | ||||
Thread | Forum | |||
G16 starter and clutch spinning, engine is not | Gas Yamaha | |||
Spinning sound from clutch area | Gas Club Car | |||
clutch spinning on clones crank. AGAIN | Clone Engine Swaps | |||
"Spinning" Noise from Clutch After Stopping | Gas Club Car | |||
clutch spinning on clones crank | Clone Engine Swaps |