2000 club car moves without hitting pedal

[Sergio]

Originally Posted by Jake_Daddy

Could the pedal be adjusted so far off that its causing it to move? In reverse with less power it may not seem like its moving but is still completing the circuit.

Yes but If that is the case You will hear the Solenoid "click" as you turn the Key Switch ON/OFF and the reverse buzzer should have worked as normal.

[Outdoorsguy83]

Well it only jumps, it doesn't keep going forward. Kinda like when you put an old car into drive with low trans fluid

[Outdoorsguy83]

And no, the pedal doesn't do anything. Forward or reverse

[Sergio]

Make sure You installed the pedal micro-switch properly.

There should be 3-terminals on that switch and You need to use the COM and NC terminals.

[Outdoorsguy83]

Yes, no matter which way I connect the wires it does the same thing. There's 2 wire connections, and the arm that gets tripped when shifting from forward to reverse

[Sergio]

Lift one rear wheel and put the cart in Forward.

Do you hear or feel the solenoid click as you turn the Key Switch On/Off?

[Jake_Daddy]

So another question would be did you just get the cart and it’s always done this or is this a new problem? If the wiring is right it should be pretty easy to diagnose, I have basically the same cart and while I am dying to upgrade to solid state I sure like how simple these are.

[Outdoorsguy83]

Yes, the with the cart in forward or reverse, the solenoid clicks and the cart tries to move when I turn the key on

[Outdoorsguy83]

I bought the cart from someone else.. They said the cart had a seized electric motor, but it moves so I figured that to be untrue

[Sergio]

You need a 3 tab microswitch in the Vglide and you need to use the COM and NC tabs.