EZGo EC25-3PG bolt torque specs

[JetDoc]

I seem to be asking the same question as a lot of other people. I am rebuilding a 1990 EZGo Marathon with a EC25-3PG engine. I can't find a manual to get the engine bolt torque specs. I am busting it clear down to the crank. I printed out the manual for the EC25-2. Can the same specs be used for the -3PG? Thanks

[vince362291]

http://www.box.net/shared/3habgxrtgz

[vince362291]

theres the owners manual for the 3pg motor

[Bob-0]

Originally Posted by JetDoc

I seem to be asking the same question as a lot of other people. I am rebuilding a 1990 EZGo Marathon with a EC25-3PG engine. I can't find a manual to get the engine bolt torque specs. I am busting it clear down to the crank. I printed out the manual for the EC25-2. Can the same specs be used for the -3PG? Thanks

I'm out flying, so it will be a few days before I can get to the shop to look.... Going from memory though.... The head bolts are 20 ft/lbs.... Make sure to tighten half torque, wait 5 minutes then torque the rest of the way down. The cylinder bolt torque is high enough that you can hand tighten them with the box end of a 9/16" wrench. Tight to your hearts content on that one.

The case bolts are what I need to look up... IIRC they are around 12 ft/lbs or so

[JetDoc]

Thanks vince362291 and Bob-0. This info will help tons.

[JetDoc]

Out flying! I like it. What do you fly? Any Bombardier jets?