|
|
|||||||
| Gas EZGO Gas EZGO Marathon, Medalist, TXT and RXV. |
  |
|
|
Thread Tools | Display Modes |
07-24-2015, 10:58 AM
|
#1 |
|
Not Yet Wild
Join Date: Jul 2015
Posts: 2
|
Workhorse ST 350 runs poorly
Newby here.
Just picked up a Workhorse ST350, mfg code A203, Robin engine model EH35C. She's not pretty but was cheap. Starts and runs, barely, have to choke the sh*t out of it, no power, smells rich. I'll start w/ obvious fuel and air filter, but seller said it was running good recently at 1000 feet elevation. I'm at 2600-not sure if that matters. Suggestions or links to manuals, etc? |
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
07-24-2015, 02:10 PM
|
#2 |
|
Gone Wild
 Join Date: Sep 2010
Location: Florida
Posts: 1,895
|
Re: Workhorse ST 350 runs poorly
My first suggestion would be to clean out the carb and fuel system, If your having to choke it that much, it points to either clogged carb, fuel pump/bad gas, or low compression...
|
|
|
|
|
07-24-2015, 07:08 PM
|
#3 |
|
Not Yet Wild
Join Date: Jul 2015
Posts: 2
|
Re: Workhorse ST 350 runs poorly
So after plugs and filters, One plug had a lot of oil and grit on it. Ran pretty good for about a mile. Then it didn't. Started with light popping on decel, then more popping then a Big Bang, clunk, crack, died and now won't turn over. Blown up?
|
|
|
|
|
07-24-2015, 09:28 PM
|
#4 |
|
Getting Wild
Join Date: Sep 2013
Location: Hoffman Estates, IL
Posts: 121
|
I have that motor that I want to sell if you need a good complete for parts
|
|
|
|
|
07-25-2015, 09:30 AM
|
#5 |
|
Gone Wild
Join Date: Dec 2009
Location: Corpus Christi, TX
Posts: 1,644
|
Re: Workhorse ST 350 runs poorly
Throw a clone in it and be happy if its blown up.
|
|
|
|
|
07-26-2015, 08:44 AM
|
#6 |
|
Gone Wild
Join Date: Dec 2009
Location: Aiken, SC
Posts: 13,173
|
Re: Workhorse ST 350 runs poorly
See if you can spin it backwards by hand, if so you dropped a connecting rod. Fixable, yes but if it did I would either rebuild it, buy a better rebuilt one or clone it.
|
|
|
|
|
||||||
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| 88 2pg runs poorly even after rebuild, etc. aaauuuggh! | Gas EZGO | |||
| Early gas g2. Once warm, runs very poorly at higher rpm | Gas Yamaha | |||
| 97 workhorse runs on one cylinder only | Gas EZGO | |||
| G1 exhaust loud and runs poorly | Gas Yamaha | |||
| EZ GO Workhorse runs, but does not move | Gas EZGO | |||
Linear Mode
