|
12-16-2016, 03:41 AM
|
#21 | |
|
Old Sky Soldier
 Join Date: Dec 2011
Location: Kentucky
Posts: 3,881
|
Re: Question about my solenoid
Quote:
 |
|
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
12-16-2016, 11:35 AM
|
#22 |
|
Gone Wild
Join Date: Sep 2010
Location: Angleton,TX.
Posts: 177
|
Re: Question about my solenoid
mrgolf.... I tested the voltage regulator and it's good reading at 15.0 at governed speed.
|
|
|
|
|
12-16-2016, 11:41 AM
|
#23 |
|
Gone Wild
Join Date: Sep 2010
Location: Angleton,TX.
Posts: 177
|
Re: Question about my solenoid
it's charging the battery
|
|
|
|
|
12-16-2016, 11:59 AM
|
#24 |
|
Old Sky Soldier
Join Date: Dec 2011
Location: Kentucky
Posts: 3,881
|
Re: Question about my solenoid
You have to have a bad connection somewhere then.:
|
|
|
|
|
12-16-2016, 01:47 PM
|
#25 |
|
Gone Wild
Join Date: Sep 2010
Location: Angleton,TX.
Posts: 177
|
Re: Question about my solenoid
I have tested continuity on all of the wiring plus cleaned all the connections. Yeah....it's got me going mad!!
|
|
|
|
|
12-16-2016, 02:12 PM
|
#26 |
|
Getting Wild
Join Date: Sep 2016
Location: Bel Air, MD
Posts: 140
|
Re: Question about my solenoid
load test that battery, even at 12.3 v its kinda low. if all is good, check the micro switch
|
|
|
|
|
12-16-2016, 02:42 PM
|
#27 |
|
Gone Wild
Join Date: Sep 2010
Location: Angleton,TX.
Posts: 177
|
Re: Question about my solenoid
I recently replace the battery with a brand new battery. Also, replaced the solenoid and FWD/REV micro switch.
|
|
|
|
|
12-16-2016, 02:46 PM
|
#28 |
|
Gone Wild
Join Date: Sep 2010
Location: Angleton,TX.
Posts: 177
|
Re: Question about my solenoid
i also ran a continuity test on all the micro switches and they tested fine.
I was looking over the my 2000 maintenance and service manual. On the wiring diagram in the book it's showing a diode that goes on the small terminals on the solenoid. I do not have one on my solenoid. Would that might be the problem? |
|
|
|
|
12-20-2016, 07:19 PM
|
#29 |
|
Gone Wild
Join Date: Sep 2010
Location: Angleton,TX.
Posts: 177
|
Re: Question about my solenoid
I installed a brand new solenoid and ran a test on the voltage regulator.
I put my red probe on the large post of the solenoid with the red wire from the voltage regulator attached. I put the black probe on the negative battery post. Turned the key on and started the motor and it read 12.9 volts. When i pressed the pedal down the volts dropped down to 3 volts. When i let off the gas for the motor to idle it went back to 12.9 V. Can anyone help please? |
|
|
|
|
12-23-2016, 05:43 PM
|
#30 |
|
Gone Wild
Join Date: Sep 2010
Location: Angleton,TX.
Posts: 177
|
Re: Question about my solenoid
it was the voltage regulator
|
|
|
|
 |
|
||||||
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Solenoid question | Electric EZGO | |||
| Question about solenoid | Electric Club Car | |||
| Solenoid question 36 or 48v | Electric EZGO | |||
| Solenoid question | Gas EZGO | |||
| Solenoid Question | Electric EZGO | |||
Linear Mode
