|
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
07-27-2020, 07:10 AM | #1 |
Not Yet Wild
Join Date: May 2020
Posts: 18
|
Cable Upgrade
Hello gang. Just a quick question. I am doing a 2ga upgrade on my PDS. Already changed all the pack cables, cable to solenoid, solenoid to controller. Anything else I am missing? Also, I read some where that only 2 of the 4 wires wires to the motor need changed. Can some one tell me which 2 they are? Thanks.
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
07-27-2020, 12:49 PM | #2 | |
Techno-Nerd
Join Date: Jun 2011
Location: West Virginia
Posts: 19,654
|
Re: Cable Upgrade
Quote:
5 - Connecting the batteries in series. 1 - Battery pack's B+ to solenoid's battery side large terminal. 1 - Solenoid's controller side large terminal to controller's B+ terminal 1 - Controller's B+ terminal to Motor's A2 stud. 1 - Controller's M- (labeled A1 on stock PDS controller) to motor's A1 stud. 1 - Battery packs' B- terminal to controller's B- terminal. The thinner (10Ga) wires connecting the controller's F1 & F2 terminals to the motor's F1 & F2 studs only carry up to 30A and don't need to be replaced unless damaged. Check for worn insulation where they are routed around battery box frame. |
|
|
Thread Tools | |
Display Modes | |
|
Similar Threads | ||||
Thread | Forum | |||
2G cable upgrade | Electric Club Car | |||
06 precedent 2G cable upgrade along with Alltrax 500 upgrade | Electric Club Car | |||
Cable Upgrade - TXT 48V | Electric EZGO | |||
Cable Upgrade | Electric EZGO | |||
ez-go pds cable upgrade | Electric EZGO |