![]() |
|
Gas Club Car Gas DS, and Precedent golf cars |
![]() ![]() |
|
Thread Tools | Display Modes |
|
![]() |
#1 |
Not Yet Wild
![]() Join Date: Jun 2018
Location: St.Louis Mo
Posts: 14
|
![]() ok , i have a 89 CC ds gas, 3 inch lift. when on flat land it goes about 20 21 mph as i go up a incline(decent size ) cart slows down to a crawl and starts to shake then come to a compete stop. so i changed out both clutches thinking that would fix my problem..No tried to climb hill again cart slowed down and started to shake again. I have a kaw motor called flathead????? has this happen to anyone i heed help
|
![]() |
![]() |
![]() |
#2 |
Gone Insane
![]() ![]() Join Date: Oct 2016
Location: Richmond, VA
Posts: 14,220
|
![]() How steep/long is the incline?
|
![]() |
![]() |
![]() |
#3 |
Not Yet Wild
![]() Join Date: Jun 2018
Location: St.Louis Mo
Posts: 14
|
![]() It’s not a hill where it goes to flat to hill, it a hill (grass) that gradually goes up. What are your thoughts
|
![]() |
![]() |
![]() |
#4 |
Gone Insane
![]() ![]() Join Date: Oct 2016
Location: Richmond, VA
Posts: 14,220
|
![]() I'm still wondering how steep and long the incline is.
|
![]() |
![]() |
![]() |
#5 |
Not Yet Wild
![]() Join Date: Jun 2018
Location: St.Louis Mo
Posts: 14
|
![]() This is the hill
|
![]() |
![]() |
![]() |
#6 |
Gone Insane
![]() ![]() Join Date: Oct 2016
Location: Richmond, VA
Posts: 14,220
|
![]() If my SWAG is correct, that hill is roughly 40-43 degrees. I don't know if that cart is supposed to climb something like that. Dang. Pretty steep. I'll have to check into this a bit.
![]() ![]() Off the top of my head I think it's a bit too steep. |
![]() |
![]() |
![]() |
#7 |
Gone Insane
![]() ![]() Join Date: Oct 2016
Location: Richmond, VA
Posts: 14,220
|
![]() Anybody got the info on max hill climbing for these?
|
![]() |
![]() |
![]() |
#8 |
Photoshop Guy
![]() Join Date: Aug 2012
Location: Canal Fulton, OH
Posts: 3,957
|
![]() I would not expect either one of my flathead carts with 22" tires to make it up a hill that steep, and wouldn't be surprised if an OHV motor couldn't do it either. Sounds like you just replaced two perfectly good clutches.
|
![]() |
![]() |
![]() |
#9 |
Gone Insane
![]() ![]() Join Date: Oct 2016
Location: Richmond, VA
Posts: 14,220
|
![]() |
![]() |
![]() |
![]() |
#10 |
Not Yet Wild
![]() Join Date: Jun 2018
Location: St.Louis Mo
Posts: 14
|
![]() No the clutches both had grooves on the side walls. Ok Do u think I should have changed the belt also? My cart goes at least 20 mph on flat ground, but whenever I have to put a load on cart it seems like it has not enough power to get over a curb.... I don’t no what else to do
|
![]() |
![]() |
![]() |
|
Thread Tools | |
Display Modes | |
|
![]() |
||||
Thread | Forum | |||
36v series motor what is acceptable voltage loss at the motor going up a hill | Electric EZGO | |||
How much power loss will we have??? | Lifted Golf Carts | |||
Loss of Power and Batteries Loss Charge Faster | Electric EZGO | |||
Loss of Power | Electric EZGO | |||
Power loss | Gas Club Car |