PDS beep code, 3-4

[JGDUSC]

Hello all. Have a cart that won't go. Do here solenoid click when pushed and cart jumps ever so slightly. Maint mode and pedal pushed i hear 3-4 beeps. No beeps when just putting in maintenance mode other than to let me know its in. Looking through the tech manual didn't really help any. Hoping you guys have some suggestions here.

I haven't opened the cover to inspect the wires but will do so here in a bit. Assuming all is well there, next step?

A little background with this problem child.

1st time it wouldn't go, replaced the controller with an used one and it worked.
2nd time two months later the Speed sensor wire damaged or unit failed. Replaced and operated fine

Not no go again and this is the error code. Thanks for any and all suggestions!

[usgicollector]

Check all connections at the motor and controller make sure they are tight.

[scottyb]

3-4 is open field = 1 of 3 things I think
1. F1 or F2 wire bare and shorted (see below)
2. Motor failure
3. controller failure

[JGDUSC]

Thanks to both of you. Will take a closer look when I get home and report back.

Luv this place!

[JGDUSC]

Loose wire on the motor. Should have checked it first before coming here. First time I have ever seen that error code and guess I panicked. Thanks to you both!!!!!

[rib33024]

3-4 code

Field winding open. Solenoid clicks, will not run.

Check motor & controller field connections, replace power
harness or motor, if required

[Bodein]

Anyone having any luck With fixing a 3-4 fault code o. A ruff @ Tuff golf cart ! It had been running fine for about a year then whil being driven by someone who doesn’t know anything but turn the key and hit the pedal , didn’t understand delta q or maintenance requirements and now can’t even get any movement or. Solenoid pull n . It’s showing 3-4 code. I have checked and replaced any suspect connections. . Checked and qalconfirmed or replaced