HV relay kicked in on the last two charges. Hmmm

[DaveTM]

Now, just a few things first.

--My cells were getting somewhat out of balance....not like full volts or anything...so I switched the ZEVA balancing option to "DYNAMIC". By default the BMS16 uses a dynamic balance threshold, where any cells more than 1mV above the average receive balancing.

This usually brings the cells balanced very close.

--Then I switch the balancing setup back to my specs.

...Max charge voltage of my charger is set to 57V. The pack always charges to 57.3V on this setting.
...BMS Max V per cell is 4.01
...Balance V per cell is 4.07
...Full V is 56V

Now, when I look at the monitor (after the HV has terminated charging) the highest cell is under the 4.01. I did not take a pic of the monitor, but when I charge it today I'll see if I get another HV shutoff and I will take a pic of the individual cell voltages.

I just thought it a bit unusual that I'm suddenly getting HV shutdowns on two consecutive charges as I've never had this occur before.

Any thoughts on this would be appreciated.