|
|
|||||||
| Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
  |
|
|
Thread Tools | Display Modes |
07-07-2017, 09:30 PM
|
#1 |
|
Getting Wild
 Join Date: Apr 2017
Location: Hickory NC
Posts: 137
|
Help with alignment after 4" lift
I cannot find a way to adjust the alignment and on my 98 TXT, I read that you should be able to turn the tie rod end either direction, I have a few threads on each side to use but it won't budge, so I end up with this
 Sent from my iPhone using Tapatalk |
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
07-07-2017, 11:39 PM
|
#2 |
|
Getting Wild
Join Date: Jun 2017
Location: central Alabama
Posts: 85
|
Re: Help with alignment after 4" lift
should be locknuts at tie rod ends. one will have left hand threads. back locknuts off and you should be able to turn the tie rod.
|
|
|
|
|
07-08-2017, 08:56 AM
|
#3 |
|
Getting Wild
Join Date: Apr 2017
Location: Hickory NC
Posts: 137
|
Re: Help with alignment after 4" lift
Is this what you are talking about? If so these are either welded or something because I gave it everything I had on both sides and they didn't budge either direction.
 Sent from my iPhone using Tapatalk |
|
|
|
|
07-08-2017, 09:18 AM
|
#4 |
|
Getting Wild
Join Date: Jun 2017
Location: central Alabama
Posts: 85
|
Re: Help with alignment after 4" lift
Yes that looks like it. Should be another one on the other end of the tie rod. Normally you loosen both ends and turn the rod in between the ends. One end should have left hand threads. Can you get a wrench on it and tap it with a hammer. Its kinda hard to tell from the pics, but looks like the camber may be off. Is there an adjustment for camber with the new lift.
|
|
|
|
|
07-08-2017, 09:55 PM
|
#5 |
|
Gone Wild
Join Date: Jun 2015
Location: St. Augustine, FL
Posts: 328
|
Help with alignment after 4" lift
I had to put mine in a vice, use a large adjustable wrench, and hit it with a 3 lb sledgehammer as hard as I could to break those nuts free on mine. Just make double sure you are turning it the correct way!
Sent from my iPhone using Tapatalk |
|
|
|
|
07-09-2017, 09:17 AM
|
#6 |
|
Getting Wild
Join Date: Apr 2017
Location: Hickory NC
Posts: 137
|
Re: Help with alignment after 4" lift
I finally was able to break it loose, thanks for all the replies.
|
|
|
|
|
|
||||||
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| 2000 TXT alignment? 5" apart? | Electric EZGO | |||
| G29 alignment after lift.... HELP lol | Gas Yamaha | |||
| 1994 Marathon Front Wheel Alignment (Post-Jake's 4" Lift) | Gas EZGO | |||
| Installed 6" Madjax Lift, cannot figure out alignment ? | Lifted Golf Carts | |||
| Club Car Madjax 6" lift alignment ? | Lifted Golf Carts | |||
Linear Mode
