EZGO TXT Dash Wiring (TIFU)

[blkgld]

So Today I F'd Up.

Went to replace the lights as the LEDs were burnt out. I bought the same style and manufacturer as original, but they had updated the plugs so I need to re-run all the wiring and in doing so, accidentally pulled out my ignition wires from behind the dash.

Whats the best way to go about getting the dash off to replace these wires, and to run the new headlight switch up?

Seems like I'm blocked on the underbody from really getting a hand in there and have to remove the dash itself, so replace a handful of rivets (What type?) while I'm at it.

[camaroluvz28]

The key switch plate comes off by knocking the two small rivets on the bottom through...why remove the entire dash?

[blkgld]

Originally Posted by camaroluvz28

The key switch plate comes off by knocking the two small rivets on the bottom through...why remove the entire dash?

How do you run the wires up on the underside? There’s a large plate on the underside blocking access on mine

[camaroluvz28]

The plate should be plastic and have holes where the wires run through close to the frame

[blkgld]

Originally Posted by camaroluvz28

The plate should be plastic and have holes where the wires run through close to the frame

So fish tape to grab the wires then?

I assume it’s these two I can pop out somehow?

[blkgld]

Got it out of there, always worried about breaking something and not finding a replacement part. Now to figure out which wire is which for the ignition switch

[meimk]

If it's the 2 wire switch, it doesn't really matter which is where. Either way the switch just completes the circuit.