08-09-2010, 06:41 PM | #1 |
Not Yet Wild
Join Date: Jul 2010
Posts: 11
|
shift problem
Was wondering if any of you pros out there could give some advice? I was driving my CC gas around for about 2-3 hours with no problems then when I went to back up it was really hard to shift. I believe the shift cable is bad because I could feel it rubbing the inside aluminum sleeve but was wondering what else would cause this. It still goes into reverse just fine but is stiff when shifted.
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
08-10-2010, 03:18 PM | #2 |
Gone Wild
Join Date: May 2010
Location: NW Indiana
Posts: 283
|
Re: shift problem
One way to narrow it down, would be to unhook the cable at the rear end, and try to shift it by hand or move the lever/cable when it is unhooked from the rear end. That would take either one or the other out of the equation for ya.
|
08-11-2010, 09:07 PM | #3 |
Not Yet Wild
Join Date: Jul 2010
Posts: 11
|
Re: shift problem
Cool thanks, I will try that!!
|
|
|
Similar Threads | ||||
Thread | Forum | |||
Shift Lever | Gas EZGO | |||
shift cable problem | Gas Club Car | |||
hard shift? | Gas Club Car | |||
Electric shift | Big Block Talk! | |||
shift eez | Gas Yamaha |