|
|
|||||||
| Electric Club Car Electric DS, and Precedent golf cars |
  |
|
|
Thread Tools | Display Modes |
04-24-2016, 09:06 PM
|
#1 |
|
Not Yet Wild
Join Date: Sep 2014
Posts: 3
|
Pre charge resistor burned
48 volt cc 4 batt. Noticed the pre charged resistor melted until I unhooked battery.any ideas? Also there is a red wire lead from battery 1 and blue wire lead from batt 4 where do these wires go?thanks
|
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
04-24-2016, 09:27 PM
|
#2 |
|
Gone Wild
Join Date: May 2012
Location: Rio Verde, Az
Posts: 7,183
|
Re: Pre charge resistor burned
Solenoid failure is often a cause of this.
|
|
|
|
04-24-2016, 09:34 PM
|
#3 |
|
Happy Carting
 Join Date: Dec 2007
Location: Southern California
Posts: 73,418
|
Re: Pre charge resistor burned
When the solenoid fails to energize, the controller will attempt to power the motor through the pre-charge resistor. Likely this is what happened. Either the solenoid failed when asked to energize OR the solenoid activation circuit failed.
So 2 possibilities, solenoid failure or solenoid activation failure |
|
|
|
|
|
||||||
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Burned controller -- Can you ID this IC OR Resistor? | Electric EZGO | |||
| Burned resistor values | Electric EZGO | |||
| Pre-Charge resistor | Electric EZGO | |||
| Pre-charge resistor for resistor carts? | Electric EZGO | |||
| 5TH speed resistor has a burned mark on resistor board and melted the wire | Electric EZGO | |||
Linear Mode
