|
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
05-07-2018, 07:50 AM | #1 |
Gone Wild
Join Date: Feb 2018
Posts: 185
|
RXV Voltmeter Wiring Options?
Hey, new to me RXV, has the analog SOC indicator, but I like numbers. I wanna check my plan before I go.
My search through the threads shows or suggests 3 ways to wire the switched voltmeter: 1. (implied) wire the LED in parallel to the existing analog meter; 2. there is an existing plug in the panel that be used RED/BLCK/GRY; 3. run RED wire to the "keyed" post of the solenoid (not the post with small wires?), BLCK to B-. Do I have these right? Seems parallel splice into the analog meter is easiest rather than running wires. Thanks for guidance. This is a great site! |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
05-07-2018, 08:00 AM | #2 |
Gone Wild
Join Date: Mar 2014
Location: NE Indiana & SW Florida
Posts: 3,238
|
Re: RXV Voltmeter Wiring Options?
Do Not splice into the wiring harness. Just get this meter and I think you will be happy.
EZGO RXV Charge Meter Plug And Play Multifunction It's plug and play... |
05-07-2018, 09:25 AM | #3 |
Over This Interview Is...
Join Date: Jun 2012
Location: AZ
Posts: 17,449
|
Re: RXV Voltmeter Wiring Options?
If you don't get the plug & play meter listed above, use your "option 3", it's the only safe one.
|
05-07-2018, 11:42 AM | #4 |
Gone Wild
Join Date: Feb 2018
Posts: 185
|
Re: RXV Voltmeter Wiring Options?
Ok, NO SPLICED CONNECTIONS!
Hooking to solenoid would be the cheapest route, but it is certainly convenient to plug and play. Thanks for the advice! |
05-07-2018, 05:40 PM | #5 |
Gone Insane
Join Date: Oct 2015
Location: TN/NC/GA Tri-state area
Posts: 3,952
|
Re: RXV Voltmeter Wiring Options?
Yea, the factory SOC meter is not a "meter" in the voltage sense. It is a 5 volt digital readout connected to an I/O port (grey wire) on the controller. It has a simulated analog needle output.
The plug & play digital readout is designed to work with the controller I/O. |
|
|
Similar Threads | ||||
Thread | Forum | |||
SOC voltmeter wiring question | Electric EZGO | |||
wiring stereo and voltmeter 36 volt EZGO | Electric EZGO | |||
Digital voltmeter wiring | Electric Club Car | |||
Wiring a voltmeter to G2 | Electric Yamaha | |||
Wiring a voltmeter on 90 club car? | Electric Club Car |