Alltrax install

[Delgrad59]

New to the forum. Did some searching but couldn’t find my exact issue. Installed alltrax 500 controller and heavy duty solenoid. Put it together and I get nothing. Connected the monitor and I throw low throtle input and overcurrent flags and shutdown as soon as I turn the key. The motor amps spike to like -1300. I noticed the throotle type is for ez go but I got a club car. Is that it or should I look for something else. Also how would I get the right map?

[Delgrad59]

By the way it’s a 2013 cc precedent with MCOR still intact.

[scottyb]

Go to the page where you downloaded the software and download the user manual too here > https://alltraxinc.com/alltrax-tool-kit/
Program the correct throttle type;
open the program
select tools, options, edit throttle types, ok
then go to Throttle settings tab
select Club Car MCOR
Set and wait for button to turn gray again

I think you want the EJ-4001-V9 map attached
Do not open and try to read... that may corrupt the file.
Save and upload when prompted.

[Delgrad59]

Thanks when I go to that page it is just a bunch of click boxes nothing that I can change with a drop down box. The field map says it is for an ezgo. Its a 2013

[Delgrad59]

Thanks - Read the manual - Got the MCOR throttle. I am still throwing the Overcurrent flag. I also notice that it says "Charger plugged in" true. I updated per previous comments with the "Floating/NC" three prong charger setting. Still getting the flag and Motor amps are -1000. What am I missing...

[Delgrad59]

Charger won’t work now either. Gotta be something from a wiring perspective

[Delgrad59]

Went over the wiring again and again. Now the charger doesn’t work. Is there some type of short or malfunction with obc. Is there a way to check? Everything was working fine before

[Delgrad59]

Ok charger works. I get overcurrent error. Light blinks one green one red which means short circuit/output fault. Any ideas?

[Delgrad59]

Circling back for others that may search in the future and will keep people updated.... contacted alltrax help desk. They said remove the M- wire from the controller (J9 on an XCT) then power everything back up. If the error changes it's in your motor if it stays the same it's probably the controller. Removed the wire and got the same error. Sent back the controller.

[handtools]

Thanks for the update, I appreciate it when the solutions for problems are posted.