|
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
06-03-2014, 10:31 AM | #1 |
Gone Wild
Join Date: May 2013
Posts: 552
|
Replacing controller questions. .
I have been recruited to help replace my buddies entire system. . I had him call Scottyb and he hooked him up with the #909 package. I did all mine and it was a cc, so the ezgo pds set up I'll have a few questions. It's has not been received yet so doing my homework before it gets here.
1) when replacing the controller I'm assuming the new controller will be significantly bigger so will it fit under that housing that covers the stock controller? A. Any body have any pics of a replacement they have done? 2) if it does not even go back to the original position where did you reinstall the controller at. Shout out to scottyb for hooking up a good friend here in ks with a sweet setup. I'm Sure ks is not a big buyer for cart upgrades but here in the southeast Scottyb has a good market stronghold atleast at my course, thanks. He said you talked him through everything. This is some great customer service |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
06-03-2014, 11:15 AM | #2 |
Gone Wild
Join Date: Oct 2011
Location: Ellensburg, WA
Posts: 179
|
Re: Replacing controller questions. .
Yeah the 500 amp controller is a lot bigger. I can't even get my 400amp to fit under a heavily cut cover. The biggest issue I have with that is no place to mount my run/tow switch as the alltrax controllers are more water resistant than a stock controller.
However it will fit on the heat sink you will just have to drill new holes. |
06-03-2014, 01:39 PM | #3 | |
Gone Wild
Join Date: May 2013
Posts: 552
|
Quote:
Thanks my club car was easier it was just mounted upside down above motor pain to install without removing back body but more than enough room. . Do you have any pics of the instal? |
|
|
|
Similar Threads | ||||
Thread | Forum | |||
Replacing controller | Electric EZGO | |||
replacing stock controller on PDS? | Electric EZGO | |||
Replacing Controller | Electric Club Car | |||
Replacing the F&R on 92 CC DS 36v Resistor Cart...Questions? | Electric Club Car | |||
Help please: Controller problems after replacing batteries in a 36v melex | Electric golf carts |