|
Gas Yamaha Gas Yamaha Golf Cars; G1 through "The Drive" and U-Max Utility Vehicles |
|
Thread Tools | Display Modes |
|
03-21-2014, 04:25 PM | #1 |
Gone Wild
Join Date: Jul 2010
Location: winston-salem NC
Posts: 236
|
G1 help needed
I am working on an older g1. the man said he ran it out of gas so he put more in and now it wont run. It seems to run at an idle at wide open throttle it has 100psi compression and fuel pump SEEMS to be pumping but its not a lot pouring out the line? Any ideas?
|
03-22-2014, 09:44 AM | #2 |
Searching for The Way
Join Date: Oct 2009
Location: Medina, Ohio (NEOHIO)
Posts: 11,436
|
Re: G1 help needed
If it's not pumping fuel, it's one of the following:
1. cracked fuel lines/vac line (leaking pressure) 2. fuel pump plugged (might be able to clean it out) 3. plugged fuel filter (replace) 4. weak pulse signal (bad vac line or bad compression) If it's pumping good fuel, then it's likely a dirty carburator. Disassemble and clean thoroughly. I usually take them apart, soak the parts in hot soapy water for a while, then take out one by one and scrub with a tooth brush. Rinse well, and lay out to dry overnight on a towel, blow a fan on the parts, this will dry out faster. Don't use compressed air to blow out carbs. Reassemble. Make sure your float is set correctly per the manual. |
03-22-2014, 06:18 PM | #3 |
Gone Wild
Join Date: Jul 2010
Location: winston-salem NC
Posts: 236
|
Re: G1 help needed
Thanks for all the info we will chach all the above in the morning and get back with you thanks again Harley
|
03-22-2014, 06:23 PM | #4 |
Gone Wild
Join Date: Oct 2010
Posts: 6,730
|
Re: G1 help needed
When a Mikuni pump(which is on your cart) runs out of supplied fuel, it usually has to be primed to get it to work correctly again.
|
|
Thread Tools | |
Display Modes | |
|
Similar Threads | ||||
Thread | Forum | |||
help needed | Big Block Talk! | |||
help needed | Gas EZGO | |||
Air jet needed, can you help | Gas EZGO | |||
G2 help needed!! | Gas Yamaha | |||
Help needed | Big Block Talk! |