10-10-2011, 02:32 PM | #1 |
Not Yet Wild
Join Date: Oct 2011
Location: Va
Posts: 40
|
Need help with a bolt??
I am tying to take the complete motor/tranny out. The bolt that holds the leaf spring on the side that the clutch is on is being a booger. I got the nut off but cannot get the bolt out. I tried prying, spraying wd40, impact. Anyone have any ideas on how to get it out? I was going to cut it but then the bolt would still be stuck in it. I do not have enough room on the clutch to knock it inward, and not enough room to knock it outward. What can I do?
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
10-11-2011, 08:32 AM | #2 |
Not Yet Wild
Join Date: Jul 2011
Location: Thumb of MI
Posts: 60
|
Re: Need help with a bolt??
Do what I did.. Sawzall on both sides through the rubber. It will come out and you have to repalce the bolt and rubber pieces. The steel sleeve is likley rusted to the bolt not allowing it to go through the hole in the frame. The 2 rubber pieces and the sleeve was like $5
|
10-11-2011, 01:20 PM | #3 |
Not Yet Wild
Join Date: Oct 2011
Location: Va
Posts: 40
|
Re: Need help with a bolt??
Thats a good idea. I didnt think to cut inside the frame and take it off the cart and then knock it out.
|
|
|
Similar Threads | ||||
Thread | Forum | |||
bolt size | Gas Club Car | |||
bolt pattern ? | Electric EZGO | |||
I need a bolt size | Electric EZGO | |||
96 DS stock drive clutch bolt size (exterior bolt) | Gas Club Car | |||
Bolt Patterns!!! | Electric EZGO |