|
Gas EZGO Gas EZGO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
10-10-2008, 06:28 PM | #1 |
Not Yet Wild
Join Date: Sep 2008
Location: Moscow, PA, USA
Posts: 67
|
1984 EZGO 2 Stroke Will not fire
Hello everyone. I have a small (hopefully) problem that i cannot put my thumb on. I have a 1984 EZGO cart with a 2stroke 244 cc robin engine with oil injection. I cannot get it to fire. I have done a full motor rebuild with new bearings, crank seals, crank, connecting rod, wrist pin, piston, rings, head, gaskets, air cleaner, spark plug, reed valve and gaskets. I had this cart running for about a week and during a drive, the engine just shut down. ive gone though and replaced the piston and rings, honed the cylinder, replaced the plug, air cleaner, cleaned the carb. i have spark, i have 120ish on the compression, its getting fuel, all electricals are fine. I can get it to turn over but i cannot get it to fire. Im stuck. Ive been working on carts now for a few years but this one has me stumped. any ideas? Thanks.
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
10-11-2008, 08:51 AM | #2 |
Not Yet Wild
Join Date: Oct 2008
Location: Taylor Mill, KY
Posts: 28
|
Re: 1984 EZGO 2 Stroke Will not fire
Have you checked for leaks at the crank seals even though there new? I know the slightest air leak on one of my r/c nitros and it will not even try to start.
|
10-11-2008, 12:41 PM | #3 |
Not Yet Wild
Join Date: Sep 2008
Location: Moscow, PA, USA
Posts: 67
|
Re: 1984 EZGO 2 Stroke Will not fire
I have. There are no leaks that i can hear or see. All the seals and gaskets are new. I have all the bolts torqued to EZGO's specs. And the gas is new. Being a 2 stroke, there isn't much that can go wrong to cause it not to fire. I've been working on ezgos for several years and this is the first time that i have ever had this problem. Ive even removed the muffler thinking that it was blocked, which happens all the time with the 2 strokers.
|
10-11-2008, 04:29 PM | #4 |
Not Yet Wild
Join Date: Oct 2008
Location: Taylor Mill, KY
Posts: 28
|
Re: 1984 EZGO 2 Stroke Will not fire
Did you try blowing smoke into the bottom end? You would never see if the flywheel side is leaking without a little cigar smoke
|
10-12-2008, 07:24 PM | #5 |
Golf Cart Photographer
Join Date: Jan 2007
Location: Wichita Falls Texas - My Ride 2010 Club Car
Posts: 6,236
|
Re: 1984 EZGO 2 Stroke Will not fire
Welcome to the forum itstheburns327...................
|
10-13-2008, 11:51 AM | #6 |
Gone Wild
Join Date: Nov 2007
Location: OKOBOJI, IA.
Posts: 247
|
Re: 1984 EZGO 2 Stroke Will not fire
i take it's got spark,
does the 84's have a condenser? if so , then replace it and she'll run. Dew |
10-13-2008, 12:01 PM | #7 |
Not Yet Wild
Join Date: Sep 2008
Location: Moscow, PA, USA
Posts: 67
|
Re: 1984 EZGO 2 Stroke Will not fire
Yes, there is spark. Everything is new. Ive tried that.
|
01-02-2009, 02:32 PM | #8 |
Not Yet Wild
Join Date: Sep 2008
Location: Moscow, PA, USA
Posts: 67
|
Re: 1984 EZGO 2 Stroke Will not fire
Well I thought that I would update this thread. It was the fan side crankshaft seal. It popped right out of place. Runs great, no problems!!
|
|
|
Similar Threads | ||||
Thread | Forum | |||
1984 ezgo | Gas EZGO | |||
1984 ezgo two stroke | Gas EZGO | |||
2 stroke ezgo again | Gas EZGO | |||
ezgo ? 2 stroke | Gas EZGO | |||
1984 EZGO help a newbie? | Gas EZGO |