|
Gas EZGO Gas EZGO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
05-01-2009, 05:40 PM | #1 |
Not Yet Wild
Join Date: Apr 2009
Location: Nederland, TX
Posts: 50
|
motor mount for gx390 clone
I decided to go with the the gx390 13hp clone. I fabricated a motor mount out of square tubing and a piece of diamond plate. I removed the "pointed" section of the original engine mount that was on the cart frame and welded it to a piece of 1/4" plate welded to the new mount. That way I can reuse the orinal front rubber motor mount. I also ground part of the rear axle stop to allow me just enough to level and reuse the original rear mount. Next will be to remove gravity gas tank, stock air box and filter,and governor(to attach vacuum connection for fuel pump). I'll have to fabricate a new shifter cable bracket,throttle cable bracket, air box, and intall the key switch in the dash.
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
05-02-2009, 07:04 AM | #2 |
Born Wild
Join Date: Mar 2007
Location: Clover SC.
Posts: 5,552
|
Re: motor mount for gx390 clone
Nice work, looks a little high though.
|
05-02-2009, 11:01 AM | #3 |
Not Yet Wild
Join Date: Apr 2009
Location: Nederland, TX
Posts: 50
|
Re: motor mount for gx390 clone
I had to raise it to clear the head over the differential. Once the gas tank and air cleaner or removed from the engine I should have clearance for the seat.
|
03-13-2013, 09:30 PM | #4 |
Not Yet Wild
Join Date: Feb 2012
Posts: 4
|
Re: motor mount for gx390 clone
How did the clone turn out?
|
|
|
Similar Threads | ||||
Thread | Forum | |||
need advice on clone motor swap | Gas EZGO | |||
Front motor mount | Gas EZGO | |||
Motor Mount | Gas EZGO | |||
Club Car Motor Mount | Gas Club Car | |||
G9 motor mount | Design Center |