|
Electric Yamaha Electric Yamaha Golf Cars; G1 through "The Drive" and U-Max Utility Vehicles |
|
Thread Tools | Display Modes |
06-10-2020, 07:56 PM | #1 |
Not Yet Wild
Join Date: Mar 2015
Location: Houston
Posts: 15
|
Low Hum coming from Reverse Buzzer and Cart Won't Move
Bought a project to work on with my son. It's a 2007 Yamaha G29. Just put new batteries in and when i switch tow to run, the back up buzzer makes a low steady tone and cart doesn't move. I had already replaced the solenoid when I was doing clean up. I don't know electric carts that well so open to suggestions.
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
06-10-2020, 08:09 PM | #2 |
Over This Interview Is...
Join Date: Jun 2012
Location: AZ
Posts: 17,449
|
Re: Low Hum coming from Reverse Buzzer and Cart Won't Move
That's either a bad controller, or damaged wiring harness (physically damaged, or corrosion intrusion).
|
06-10-2020, 10:09 PM | #3 |
Not Yet Wild
Join Date: Mar 2015
Location: Houston
Posts: 15
|
Re: Low Hum coming from Reverse Buzzer and Cart Won't Move
Kinda thought controller but I'll give the wiring harness a good look through. Should my solenoid have 48 volts on the controller side or does that vary by accelerator sensor? I do hear it click when I switch out of tow.
|
06-11-2020, 02:38 AM | #4 |
Over This Interview Is...
Join Date: Jun 2012
Location: AZ
Posts: 17,449
|
Re: Low Hum coming from Reverse Buzzer and Cart Won't Move
It always has B+, the B- is provided by the controller when controller thinks it should be on. And "whenever the key is turned" isnt what it does. Itll turn it on for about 5 seconds, then off again when tow/run is turned on. Wait 30 seconds like the instructions say to do.
The instructions no one reads/follows on that sticker. Yep, "jockey" that switch like a mad man, like it was your bathroom light..... nope, gonna have to wait. Following directions is for "suckers"...right? |
06-11-2020, 01:03 PM | #5 |
Not Yet Wild
Join Date: Mar 2015
Location: Houston
Posts: 15
|
Re: Low Hum coming from Reverse Buzzer and Cart Won't Move
From the research I've done, it sounds like the solenoid should click when I press the pedal down. I don't think it does. Can I jump out the accelerator sensor to see if wheels move and solenoid clicks without frying the controller?
|
06-11-2020, 01:21 PM | #6 |
Over This Interview Is...
Join Date: Jun 2012
Location: AZ
Posts: 17,449
|
Re: Low Hum coming from Reverse Buzzer and Cart Won't Move
There are 2 things at the gas pedal, one is the position sensor (3 wires & cant be "jumpered"), the other is a "stop switch" (2 wires, can be jumped).
|
|
|
Similar Threads | ||||
Thread | Forum | |||
Reverse buzzer stays and cart won’t move | Electric EZGO | |||
07 TXT will not move and no reverse buzzer | Electric EZGO | |||
Hot resistor, burned pin 5, no reverse buzzer, cart won't move | Electric EZGO | |||
Reverse Buzzer Sounds When in Forward and Cart will not move | Electric EZGO | |||
Washed Cart, now Buzzer on in F&R, will not move | Electric Club Car |