|
03-15-2013, 11:54 AM
|
#1 |
|
Not Yet Wild
Join Date: Mar 2010
Location: Florida
Posts: 28
|
RPMS for 295 robin
What are the proper rpms for a 295 ronbin & how can I adjust them? Thanks!!
|
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
03-15-2013, 12:52 PM
|
#2 | |
|
Gone Wild
Join Date: Dec 2012
Location: Warren Mi
Posts: 233
|
Re: RPMS for 295 robin
Quote:
 "sorry" I just couldn't resist  |
|
|
|
|
|
03-15-2013, 05:50 PM
|
#3 |
|
I Refuse To Get Stuck!!!
Join Date: Jun 2010
Location: Hilton,NY
Posts: 5,427
|
Re: RPMS for 295 robin
What are you looking to do?Limit Rpm,or get more?If its' stock and has the govenor hooked up,unhook it,and you will get quite a bit more RPM,with some increase in speed and overall-power.Just don't run it wide-open for more than short blasts,If you do,you will need to up your oil-mix ratio from 1oz./gal to 1-1/2oz.per gal.to help it survive,which it will at that mix,for a very long time.Hope this helps.
 |
|
|
|
|
03-15-2013, 07:23 PM
|
#4 |
|
Not Yet Wild
Join Date: Mar 2010
Location: Florida
Posts: 28
|
Re: RPMS for 295 robin
How do I unhook the governor? It's a 4 stroke in a 2003 txt.
|
|
|
|
|
03-15-2013, 07:25 PM
|
#5 |
|
Not Yet Wild
Join Date: Mar 2010
Location: Florida
Posts: 28
|
Re: RPMS for 295 robin
I guess my question was what is the highest rpms it should run without damaging the motor?
|
|
|
|
|
03-15-2013, 07:37 PM
|
#6 |
|
I Refuse To Get Stuck!!!
Join Date: Jun 2010
Location: Hilton,NY
Posts: 5,427
|
Re: RPMS for 295 robin
Sorry,I misread,thought it was a 244.The govenor runs thru the rear-axle.There are threads on disabling/bypassing it.I don't know what the actual RPM limit is,but I'm sure its' somewhere around 4000,maybe a little more.
|
|
|
|
|
03-16-2013, 07:31 AM
|
#7 |
|
Gone Wild
Join Date: Apr 2012
Location: Dansville, NY
Posts: 396
|
Re: RPMS for 295 robin
That car has a rev limiter built into the igniter, it can't be bypassed. Run it hard, the rev limiter will keep it safe. If you can find an early 90's 4 stroke igniter, they don't have the limiter.
|
|
|
|
|
03-16-2013, 02:27 PM
|
#8 |
|
Not Yet Wild
Join Date: Mar 2010
Location: Florida
Posts: 28
|
Re: RPMS for 295 robin
Thanks for the info. Learning a lot from this forum!
|
|
|
|
 |
|
||||||
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| G2 RPMS need to ask again | Gas Yamaha | |||
| RPMs | Gas EZGO | |||
| lower my rpms | Gas Club Car | |||
| HP and RPMs | Extreme DC! | |||
| low rpms only | Gas EZGO | |||
Linear Mode
