08 St sport 2+2 only 14.5 mph w governor adj

[StoveBolt]

*Cross referenced for Dayco belts*

This is your stock belt...
Length 41.750"
Width 1.188"
http://www.mfgsupply.com/atv/atvclut...lf/hp2014.html

and this one is 3/4" shorter...
Length 41.000"
Width 1.188"
http://www.mfgsupply.com/atv/atvclut...lf/hp2012.html



and click here to read up..> http://www.buggiesgonewild.com/ezgo-...en-clutch.html

per the article by Ruredy..

There are 2 shorter belts that will work on a 94 - 06 Medalist/txt/workhorse carts.

1st belt is for a Ezgo 89 -91 2cyc cart. Its 41" long, OEM # 22337-G1
At first it will run a little slower but give it some break-in time and you will get back up to speed. This will give you a great low end power for climbing and allow you to maintain your top end speed.

2nd belt is for a Ezgo 1992-1993 2cyc and 1992-1994 4cyc, it is 40 3/4" long, OEM # 27077-G02
This belt is very tight, hard to get on, and needs to run about a week before you can get it off without cutting. It will losen up a little after alot of break-in time. I would say this belt would work the best if you were running in a very wet or muddy place. I had only lost a few mph with this belt after it was broke-in. This belt will make it hard to shift from forward to reverse when stopped on a hill or incline. This problem will diminish over time.

Its very hard to tell the difference between the 2 belts as far as low end power. I will say that the first belt is the one I would use and like best.