06-20-2013, 08:27 PM | #1 |
Not Yet Wild
Join Date: Jun 2013
Posts: 7
|
help wiring hei
I have been having some problems with my 84 2pg motor so i double and triple checked wiring. i have seen a couple posts on here that show the wiring of the pulser wires to the hei modual different. can someone tell me where each should go. the one post was for a 3 pg motor would they be different from the 2 to the 3 pg??
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
06-21-2013, 06:24 AM | #2 |
Gone Wild
Join Date: Feb 2011
Posts: 1,515
|
Re: help wiring hei
Welcome to BGW The 3pg is the same wiring. Keep in mind some times for some unknown reason you may have to reverse the red and blue wire from the pulser. Another important wire is the one that attaches to the metal housed hole on the module there should be a ground wire attached at that bolt or screw. Hope this helps.
LOU |
06-21-2013, 07:10 AM | #3 |
Getting Wild
Join Date: Mar 2011
Location: Beech Grove In.
Posts: 91
|
Re: help wiring hei
Have you looked at the first Sticky note on the home page? There is a wire diagram on it.
|
|
|
Similar Threads | ||||
Thread | Forum | |||
Controller wiring/DCS fnr switch wiring | Electric EZGO | |||
Wiring Help | Gas EZGO | |||
Wiring lights and a winch? Use a converter or hard wiring? | Electric EZGO | |||
Wiring lights and a winch? Use a converter or hard wiring? | Electric EZGO | |||
Wiring help | Electric Club Car |