2022 Evolution Programming Tool

[evoster]

Originally Posted by KC-EV

Exactly what I was needing. Thank you!!

If you haven't already, look at the FJP project file that I posted here. You can use it with the programming software without connecting to your cart and then dig thru all the other tabs and parameters offline.

[nokocart]

Really great info all. Thanks!

Programming question. I would like to set my low setting top speed to match my speed limit in my neighborhood so i can just pedal to the floor and the old ladies wont report me to the HOA police. Is there a way to tune in the low speed RPM?

Thanks for any help.

[evoster]

Originally Posted by nokocart

Really great info all. Thanks!

Programming question. I would like to set my low setting top speed to match my speed limit in my neighborhood so i can just pedal to the floor and the old ladies wont report me to the HOA police. Is there a way to tune in the low speed RPM?

Thanks for any help.

Look at the Slow Mode tab. Picture attached

[nokocart]

Well I feel dumb. I didn't even see that tab. Thanks for the help the cart is happy with the new settings!

[Silvr_Scream]

Originally Posted by evoster

Look at the Slow Mode tab. Picture attached

Any experience with the electronic brake adjustment to make it not so harsh when braking?

[evoster]

Originally Posted by Silvr_Scream

Any experience with the electronic brake adjustment to make it not so harsh when braking?

It varies with controller type and associated software.
For the EV48-400 and EV48-400-A :

Turn on/off Electromagnetic brake (motor brake) function on these tabs:
- Calibration>Electromagnetic brake
- Calibration>Slop control

Turn on the Electromagnetic brake (motor brake):
- Set “Electromagnetic brake control type” to “Driver4”
- Set “Slop control mode” to “Stop in slop”
- Adjust “Electromagnetic brake release speed”
- Adjust “Electromagnetic brake release delay time”

Turn off the Electromagnetic brake (motor brake):
- Set “Electromagnetic brake control type” to “Disable”
- Set “Slop control mode” to “Slide in slop”

Besides EM settings, there's also the deacceleration settings in Zonal tab for when foot is off pedal

Calibration > Zonal gear mode >

1 partition deceleration of P mode (rpm/s)
2 partition deceleration of P mode (rpm/s)
3 partition deceleration of P mode (rpm/s)
4 partition deceleration of P mode (rpm/s)
5 partition deceleration of P mode (rpm/s)
6 partition deceleration of P mode (rpm/s)
7 partition deceleration of P mode (rpm/s)

- Setting higher “rpm/s” will provide stronger deceleration on Forward direction at
high speed mode (P mode) .
- Conversely setting smaller ““rpm/s” will provide softer deceleration

It`s recommended to adjust all the rpm range deceleration value synchronously otherwise the deceleration process may not be smooth, you may experience uncomfortable deceleration.