lifted club cars - lifted ezgo
Home FAQDonate Who's Online
Go Back   Buggies Gone Wild Golf Cart Forum > Golf Cart Repair and Troubleshooting > Electric golf carts > Tomberlin


 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 06-30-2022, 07:12 PM   #1
Jk5blazer
Not Yet Wild
 
Join Date: Jun 2022
Posts: 2
Default Tomberlin Vanish

Hello all. Just picked up a Vanish 4x4. Was hoping all that was wrong with it was the “bearing”. Order and installed new bearing, but cart still just shutters when gas pedal is applied. Batteries are brand new and fully charged. My question is how can I check the motor if it’s good. I notice the center terminal was rusted/ chard like it got very hot. When I step on the pedal it slowly goes/ shudders but doesn’t seem to stop. Almost like the pedal is stuck. The only was to get it to slow/stop is kill the “ignition” switch. Could the motor be bad/ shorted or the controller? Thanks for any info
Jk5blazer is offline   Reply With Quote
 
Go Back   Buggies Gone Wild Golf Cart Forum > Golf Cart Repair and Troubleshooting > Electric golf carts > Tomberlin


Thread Tools
Display Modes


Similar Threads
Thread Forum
Tomberlin Vanish will not go into low or park Tomberlin
2011 Tomberlin Vanish Design Center
Tomberlin vanish electric 4x4 Tomberlin
Tomberlin Vanish Upgrade Design Center
Tomberlin Vanish Tomberlin


All times are GMT -5. The time now is 02:05 PM.


Club Car Electric | EZGO Electric | Lifted Golf Carts | Gas EZGO | Used Golf Carts and Parts

Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This Website and forum is the property of Buggiesgonewild.com. No material may be taken or duplicated in part or full without prior written consent of the owners of buggiesgonewild.com. © 2006-2017 Buggiesgonewild.com. All rights reserved.