06-30-2022, 07:12 PM | #1 |
Not Yet Wild
Join Date: Jun 2022
Posts: 2
|
Tomberlin Vanish
Hello all. Just picked up a Vanish 4x4. Was hoping all that was wrong with it was the “bearing”. Order and installed new bearing, but cart still just shutters when gas pedal is applied. Batteries are brand new and fully charged. My question is how can I check the motor if it’s good. I notice the center terminal was rusted/ chard like it got very hot. When I step on the pedal it slowly goes/ shudders but doesn’t seem to stop. Almost like the pedal is stuck. The only was to get it to slow/stop is kill the “ignition” switch. Could the motor be bad/ shorted or the controller? Thanks for any info
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
06-30-2022, 08:29 PM | #2 |
Not Yet Wild
Join Date: Jun 2022
Posts: 2
|
Re: Tomberlin Vanish
Update, what would cause the three wires going to the motor to get very hot? I think I should start there
|
|
|
Similar Threads | ||||
Thread | Forum | |||
Tomberlin Vanish will not go into low or park | Tomberlin | |||
2011 Tomberlin Vanish | Design Center | |||
Tomberlin vanish electric 4x4 | Tomberlin | |||
Tomberlin Vanish Upgrade | Design Center | |||
Tomberlin Vanish | Tomberlin |