lifted club cars - lifted ezgo
Home FAQDonate Who's Online
Go Back   Buggies Gone Wild Golf Cart Forum > Golf Cart Repair and Troubleshooting > Gas EZGO
Gas EZGO Gas EZGO Marathon, Medalist, TXT and RXV.



Post New Thread  Reply
 
Thread Tools Display Modes
Old 10-04-2007, 03:06 PM   #1
Xtreme Cartz
The Fabricator
 
Xtreme Cartz's Avatar
 
Join Date: Dec 2006
Posts: 2,016
Default Dash cover will not cover

I am trying to install a dash cover on a 00 EZGO Workhorse and am having tremendous difficulty. It is a very tight fit around the cup holders. Is there a trick to make it completely slide over the cup holders? It almost seems like the dash cover was formed wrong. There is a 1'' gap between the key switch plate and the dash cover no matter how hard I push. Any tips/suggestions? Thanks
Xtreme Cartz is offline   Reply With Quote
Alt Today
BGW

Golf car forum Sponsored Links

__________________
This advertising will not be shown in this way to registered members.
Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum
   
Old 10-04-2007, 04:08 PM   #2
Xtreme Cartz
The Fabricator
 
Xtreme Cartz's Avatar
 
Join Date: Dec 2006
Posts: 2,016
Default Re: Dash cover will not cover

I finally got it to slip over the cup holders but now my little fingers hurt. I assume by the 2 holes in the dash cover and the gap between it and the old dash that the key switch plate needs to be removed and mounted to the dash cover. The key switch plate has 2 lips on the top to hold it in place. Why can't I get it to catch on the dash cover? Is it suppose to?

Where are the correct locations to drive the screws through?
Xtreme Cartz is offline   Reply With Quote
Old 06-10-2008, 09:46 PM   #3
cpu77
Getting Wild
 
Join Date: May 2008
Posts: 126
Default Re: Dash cover will not cover

I am thinking of buying a stretch plastic dash cover. I wondered how the fit and finish is? My dash where the molding meets the body is gaulged pretty deep in a couple spots. I was hoping one of these would cover that up. Can you even see the old dash or does it complete cover and lay flush to the body?


Thanks
Ralph
cpu77 is offline   Reply With Quote
Old 06-10-2008, 10:14 PM   #4
BRS
Master BS'r
 
BRS's Avatar
Club Car
 
Join Date: Jul 2007
Location: S. Florida
Posts: 1,819
Default Re: Dash cover will not cover

over the cupholders...is that right? It just sounds wrong, I had to remove my stock cupholders but it should be very obvious.
BRS is offline   Reply With Quote
Old 06-10-2008, 11:16 PM   #5
cpu77
Getting Wild
 
Join Date: May 2008
Posts: 126
Default Re: Dash cover will not cover

Can someone show me a picture of one installed from the front looking down on it?
cpu77 is offline   Reply With Quote
Reply
Go Back   Buggies Gone Wild Golf Cart Forum > Golf Cart Repair and Troubleshooting > Gas EZGO


Thread Tools
Display Modes


Similar Threads
Thread Forum
EMP made the cover story of Golfcar adviser Announcements
Dash trim? Gas Yamaha
Club Car dash Golf Carts and Parts


All times are GMT -5. The time now is 03:37 AM.


Club Car Electric | EZGO Electric | Lifted Golf Carts | Gas EZGO | Used Golf Carts and Parts

Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This Website and forum is the property of Buggiesgonewild.com. No material may be taken or duplicated in part or full without prior written consent of the owners of buggiesgonewild.com. © 2006-2017 Buggiesgonewild.com. All rights reserved.