|
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
07-01-2014, 09:13 PM | #1 |
Not Yet Wild
Join Date: Jun 2014
Posts: 9
|
2008 PDS license plate light install
Have a 12v light kit but not sure how to install. It appears that I just tie into the tail lights and then run the other wire to the battery ground.
How do I know which wires are the "on" tail lights as opposed to the brake etc...? Is there an easy way to do this? I can't take the body off so I assume I will have to tie into the tail lights by splicing the wire and putting together via a host. I am very new to this so any help is appreciated!!! Just bought cart this past weekend. Thanks in advance! |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
07-02-2014, 07:38 AM | #2 |
Not Yet Wild
Join Date: Jun 2014
Posts: 9
|
Re: 2008 PDS license plate light install
Bump...Anyone?
|
07-02-2014, 10:57 AM | #3 |
Techno-Nerd
Join Date: Jun 2011
Location: West Virginia
Posts: 19,654
|
Re: 2008 PDS license plate light install
If it is a factory wiring harness, you want to tap into the Blu/Wht wire.
If it is an aftermarket kit, it could be any color. |
07-03-2014, 07:42 AM | #4 |
Not Yet Wild
Join Date: Jun 2014
Posts: 9
|
Re: 2008 PDS license plate light install
Thanks JB!
I tried that and it worked however it stayed on even when I shut the lights off. I believe I tied into the white wire before the connector. I'm assuming I need to tie into it after the connector because before is always on. Does that make sense? |
07-03-2014, 07:46 AM | #5 |
Gone Mad
Join Date: Oct 2009
Location: Buford, GA
Posts: 8,988
|
Re: 2008 PDS license plate light install
I'm not sure about any connector, but try tracing wires from the tail lights and tap into those.
|
07-03-2014, 07:49 AM | #6 |
Not Yet Wild
Join Date: Jun 2014
Posts: 9
|
Re: 2008 PDS license plate light install
I did that. There is a white plastic housing with a connector inside that connects the wires from the batteries to the wires on the rear lights. I tied into the wires coming from the battery before the white connector.
I'm assuming there is a kill switch in that connector so I need to tie into the wire on the other side of it. |
07-03-2014, 09:52 AM | #7 |
Techno-Nerd
Join Date: Jun 2011
Location: West Virginia
Posts: 19,654
|
Re: 2008 PDS license plate light install
You need to tap into the Blu/Wht wire after the keyswitch.
|
|
|
Similar Threads | ||||
Thread | Forum | |||
BGW license plate? | Electric EZGO | |||
I know it's simple, but.... can anyone help with connecting a License Plate light? | Electric EZGO | |||
Front License Plate | On Road Golf Carts! | |||
License Plate on an RXV | Electric EZGO |