lifted club cars - lifted ezgo
Home FAQDonate Who's Online
Go Back   Buggies Gone Wild Golf Cart Forum > Golf Cart Repair and Troubleshooting > Electric EZGO
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV.



Post New Thread  Reply
 
Thread Tools Display Modes
Old 07-25-2016, 08:23 PM   #1
flroyaltyjr
Not Yet Wild
Taylor-Dunn
 
Join Date: Mar 2012
Location: https://t.me/pump_upp
Posts: 69
Default 1982 EZGO TXT Marthon F&R switch problem

okay I am electric stupid.....thru all the diagrams I have figured out the wiring for the 4 large cooper post on the switch but cannot figure out the 2 micro switches on it. can someone plz explain what small wires go to them. I have had 3 meltdowns trying to guess...I need it in very simple terms or simple line drawing...
flroyaltyjr is offline   Reply With Quote
Alt Today
BGW

Golf car forum Sponsored Links

__________________
This advertising will not be shown in this way to registered members.
Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum
   
Old 07-25-2016, 08:50 PM   #2
Filthy-Beast
Not Yet Wild
 
Join Date: Jun 2016
Location: Chicago Area
Posts: 73
Default Re: 1982 EZGO TXT Marthon F&R switch problem

is this a series cart with F/R switch?

The first micro switch detects that the F/R switch is either in forward or reverse and not neutral. It then sends power to the throttle micro switch.

A wire from the key switch runs to the micro switch 1. So that it gets power only when the key is on. Then a wire from other side of this switch to the throttle micro switch.

the 2nd switch is just to turn on the reverse beeper. you jumper a wire from the output of the first switch to the 2nd. so it only gets power when that switch is active. Then run a wire from the other side of switch 2 to the beeper. Other wire on the beeper goes to battery pack negative.
Filthy-Beast is offline   Reply With Quote
Old 07-25-2016, 09:02 PM   #3
Sir Nuke
Master of All Things
 
Sir Nuke's Avatar
E-Z-GO
 
Join Date: May 2013
Location: West Columbia, Texas
Posts: 17,992
Default Re: 1982 EZGO TXT Marthon F&R switch problem

This should get you going

early fnr diagram.jpg
Sir Nuke is offline   Reply With Quote
Old 07-27-2016, 09:40 AM   #4
flroyaltyjr
Not Yet Wild
Taylor-Dunn
 
Join Date: Mar 2012
Location: https://t.me/pump_upp
Posts: 69
Default Re: 1982 EZGO TXT Marthon F&R switch problem

Okay thanks for the drawing....here is my problem there is no harness to pull these wires from so what I am asking is where the 2 blue wires go and where does the orange wire go. I am running these wires myself as no harness.
flroyaltyjr is offline   Reply With Quote
Old 07-27-2016, 10:08 AM   #5
JohnnieB
Techno-Nerd
 
JohnnieB's Avatar
E-Z-GO
 
Join Date: Jun 2011
Location: West Virginia
Posts: 19,654
Default Re: 1982 EZGO TXT Marthon F&R switch problem

First we need to identify which drive system you have.

The drawing posted is for a cart with a speed controller and a 82 Marathon has a resistor drive, unless it has been retrofitted with a speed controller.

Do you have a controller or resistor drive system?

Is the motor between the batteries in front of the differential, or is it sideways mounted above the rear axle?
JohnnieB is offline   Reply With Quote
Old 07-27-2016, 10:11 AM   #6
flroyaltyjr
Not Yet Wild
Taylor-Dunn
 
Join Date: Mar 2012
Location: https://t.me/pump_upp
Posts: 69
Default Re: 1982 EZGO TXT Marthon F&R switch problem

The motor is between the batteries and it is a 36v system and it is resistor drive system.

Last edited by flroyaltyjr; 07-27-2016 at 10:12 AM.. Reason: retype
flroyaltyjr is offline   Reply With Quote
Old 07-27-2016, 10:41 AM   #7
JohnnieB
Techno-Nerd
 
JohnnieB's Avatar
E-Z-GO
 
Join Date: Jun 2011
Location: West Virginia
Posts: 19,654
Default Re: 1982 EZGO TXT Marthon F&R switch problem

Only MS-2 is used on the F/R assembly, reverse beeper is controlled by the pedal switch.

Wiring diagram attached.

Also attached service and parts manuals. Both have some useful drawings.
Attached Images
File Type: jpg Resistor ezgo -2.jpg (146.0 KB, 0 views)
Attached Files
File Type: pdf X-440 &X444 Service_Golf_Elec_80-81.pdf (4.45 MB, 0 views)
File Type: pdf x-440 & x-444 Golf_Elec_80-82-1.pdf (5.61 MB, 0 views)
JohnnieB is offline   Reply With Quote
Reply
Go Back   Buggies Gone Wild Golf Cart Forum > Golf Cart Repair and Troubleshooting > Electric EZGO




Similar Threads
Thread Forum
1989 Ezgo Marthon FnR Switch problem Electric EZGO
need a Forward Netraul Reverse switch for 1990 Marthon Golf Carts and Parts
1984 Marthon Micro switch Gas EZGO
need schematic of ign switch 1982 ezgo marathon gas Gas EZGO
1982 EZGO clutch problem Gas EZGO


All times are GMT -5. The time now is 01:16 AM.


Club Car Electric | EZGO Electric | Lifted Golf Carts | Gas EZGO | Used Golf Carts and Parts

Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This Website and forum is the property of Buggiesgonewild.com. No material may be taken or duplicated in part or full without prior written consent of the owners of buggiesgonewild.com. © 2006-2017 Buggiesgonewild.com. All rights reserved.