|
05-20-2009, 11:48 AM
|
#1 |
|
Getting Wild
Join Date: Apr 2009
Location: Augusta, GA
Posts: 122
|
EZ-wont GO
Yesterday I ran the cart for 30minutes or so. Started to do some yard work and when I got on my cart to load up some debris it didn't seem to have any power, like it's running at only half it's strength. It was running fine half an hour earlier. I tried it this morning before work and no change. I'm stumped.
|
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
05-22-2009, 02:51 PM
|
#2 |
|
Gone Wild
Join Date: Apr 2009
Location: indiana
Posts: 274
|
Re: EZ-wont GO
try taking off the vacuum line to the fuel pump and blow into it, if, you hear oil blowing out of the tube the fuel pump was not getting enough pulse from the engine vacuum, it should fire back up if it was plugged up
|
|
|
|
|
05-23-2009, 06:36 AM
|
#3 |
|
Getting Wild
Join Date: Apr 2009
Location: Augusta, GA
Posts: 122
|
Re: EZ-wont GO
I found the problem divot. It was an oil fowled spark plug. My seals are on wrong on my drivers side piston and it's letting oil get to the head.
|
|
|
|
|
05-23-2009, 08:59 AM
|
#4 |
|
Gone Wild
Join Date: Apr 2009
Location: indiana
Posts: 274
|
Re: EZ-wont GO
that s**ks,
 been there too, i just used a hotter plug for that cyl, till i could tear it down again |
|
|
|
|
05-23-2009, 12:21 PM
|
#5 |
|
Getting Wild
Join Date: Apr 2009
Location: Augusta, GA
Posts: 122
|
Re: EZ-wont GO
Well it's one of those "I wish I knew then, what I know now" situations. I didn't know that the middle and top piston head seals were different and that they had to be right side up. I didn't hone the cylinder walls when I replaced one of the piston heads either. Oh well, trial and error.
|
|
|
|
|
05-23-2009, 01:23 PM
|
#6 |
|
Happy Carting
 Join Date: Dec 2007
Location: Southern California
Posts: 73,936
|
Re: EZ-wont GO
Well, Creebo23, I gotta give ya a 'hats off' salute for putting it out there so other people who want to rebuild their own engine can learn from your rmistake
 That is pretty much what this site is all about, the collective sharing of GC knowledge  |
|
|
|
|
05-25-2009, 08:57 AM
|
#7 | |
|
Getting Wild
Join Date: Apr 2009
Location: Augusta, GA
Posts: 122
|
Re: EZ-wont GO
Quote:
|
|
|
|
|
 |
|
||||||
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| wont go | Electric Yamaha | |||
| 88 cc wont run | Electric Club Car | |||
| wont run | Gas EZGO | |||
| 91 36V CC Wont Go! | Electric Club Car | |||
| 94 Ez Go Wont Go | Electric EZGO | |||
Linear Mode
