06-20-2015, 06:09 AM | #1 |
Not Yet Wild
Join Date: Jun 2015
Posts: 3
|
Aux switch wiring help
Hello, I tried last night to wire in a led light strip to act as a dome light... I bout a mic tuning rocker switch and a wiring harness.... The switch is illuminated and if I wire it as the directions say the switch is on all the time. I would like to make the switch only powered when the key is on.... How is that possible? I want to out the switch in the dash ... Any help is greatly appreciated...
My ride is a 2007 Precedent gas. Here is the switch and wiring harness:
Amazon.com: Mictuning LED Light Bar Wiring Harness Off Road 40 Amp Relay ON-OFF Switch(2 Lead 12ft): Automotive
There are so many wires in my dash harnesses, I am sure I could tap into one the achieve the desired results, however I figured it was easier to ask as opposed to tapping each one by trial and error. |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
06-20-2015, 08:49 AM | #2 |
Getting Wild
Join Date: Jun 2014
Location: usa
Posts: 116
|
Re: Aux switch wiring help
U can use a voltage meter if u have one on igntion switch to find hot lead when on. Or just keep touching wire til it comes on Then touch with switch off.
|
Tags |
led switch precedent |
|
|
Similar Threads | ||||
Thread | Forum | |||
key switch g1 wiring | Clone Engine Swaps | |||
switch wiring | Electric EZGO | |||
Controller wiring/DCS fnr switch wiring | Electric EZGO | |||
Switch wiring | Electric Club Car | |||
Key switch wiring help | Electric EZGO |