|
06-13-2017, 07:19 PM
|
#1 |
|
Not Yet Wild
Join Date: Jul 2016
Posts: 3
|
acceleration problem
Hi Everyone ,,,
I have a 2001 EZGO TXT with a robins 2 cycle motor 292 When I accelerate the drive pulley closes up a little bit and the back pulley opens a little bit When wide open it hits Rev limiter and belt is not coming up right on drive clutch .. and I have no speed ... all is original clutches I suspect a pulley is bad . But which one?? any suggestions on what to do would be appreciated Thanks Bob |
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
06-13-2017, 08:16 PM
|
#2 |
|
Gone Wild
Join Date: Aug 2012
Location: South central IL
Posts: 287
|
Re: acceleration problem
Remove the belt, start the engine and slowly increase engine speed to see if the drive clutch closes up all the way. Dont over rev it.
|
|
|
|
|
06-14-2017, 10:09 AM
|
#3 | |
|
Not Yet Wild
Join Date: Jul 2016
Posts: 3
|
Re: acceleration problem
Quote:
|
|
|
|
|
|
06-14-2017, 01:04 PM
|
#4 |
|
Gone Wild
Join Date: Jun 2015
Location: NW Iowa
Posts: 1,669
|
Re: acceleration problem
Take the cover off check and see if anything is broke inside broken weights can make them not shift under a load causing motor to his rev limiter
|
|
|
|
 |
|
||||||
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| acceleration problem | Electric Club Car | |||
| New acceleration problem. | Electric EZGO | |||
| Acceleration problem | Electric EZGO | |||
| Acceleration Problem | Electric Club Car | |||
| '87 CC Acceleration Problem | Electric Club Car | |||
Linear Mode
