|
Gas EZGO Gas EZGO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
01-07-2019, 03:17 PM | #21 |
Gone Wild
Join Date: Jun 2016
Posts: 647
|
Re: 2 stroke and 4 stroke differences / parts swapping
had a rough time getting the motor in but it runs pretty good. buddy was assembling motor and turned it on the work bench. right when i came back into the garage he turned it so that the carb was facing the front edge of the work bench (so if it were to tip over, it would fall to the ground). long story short we walked around the corner and heard a big crash, and the assembled motor was on the ground about 45 inches down from the bench.
we thought we had put a hole in the block, or bent the crank which was brand new from the rebuild. luckily we just broke a chunk out of the fan shroud and one of the mounting holes for the fan shroud is cracked. It put a dent in the clutch as well, but lucky nothing major, we got it hammered out. crank was not bent. after we examined everything, we ended up installing it. runs good, sucks about the shroud, probably going to fab up something to fill the gap. probably should have jb welded it but I wasn't sure if it might break off at some point and get into the fan. It is near the bottom of the fan though. I have attached pictures. also, the duct/tube that runs from the carb to the air filter is in pretty bad shape. does anybody have one for sale or have a good site to grab one ? thanks |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
01-07-2019, 05:32 PM | #22 |
Gone Wild
Join Date: Mar 2015
Location: Central mn
Posts: 1,036
|
Re: 2 stroke and 4 stroke differences / parts swapping
Can you post a pic of the hose and measure total length also diameters?
I have a few that should be right. Yours free just pay shipping. |
01-08-2019, 09:19 AM | #23 |
Gone Wild
Join Date: Jun 2016
Posts: 647
|
Re: 2 stroke and 4 stroke differences / parts swapping
i will get measurements tonight, thanks! this one has been patched and has duct tape over a lot of it, don't figure it is going to last me much longer
|
01-09-2019, 08:49 AM | #24 |
Gone Wild
Join Date: Jun 2016
Posts: 647
|
Re: 2 stroke and 4 stroke differences / parts swapping
i have attached a couple pictures, let me know if you still have it and are looking to get rid of it. thanks
|
01-11-2019, 05:46 PM | #25 |
Gone Wild
Join Date: Mar 2015
Location: Central mn
Posts: 1,036
|
Re: 2 stroke and 4 stroke differences / parts swapping
I got one 2” one end 2.5” other end
Pretty sure it’s from a 2pg cart Pm me your address and I’ll send it |
01-11-2019, 05:51 PM | #26 |
Gone Wild
Join Date: Mar 2015
Location: Central mn
Posts: 1,036
|
Re: 2 stroke and 4 stroke differences / parts swapping
Pic
|
01-13-2019, 12:48 PM | #27 |
Gone Wild
Join Date: Jun 2016
Posts: 647
|
Re: 2 stroke and 4 stroke differences / parts swapping
Looks a little different but the sizes are right. I actually made one yesterday that worked for the little bit I rode it. I would absolutely use this one as a back up in case my homemade tube fails. But if you'd rather hang onto it I understand. Let me know, thanks!
|
01-13-2019, 02:32 PM | #28 |
Gone Wild
Join Date: Mar 2015
Location: Central mn
Posts: 1,036
|
Re: 2 stroke and 4 stroke differences / parts swapping
If you want it just pay shipping. Trying to clean some shelf’s, some stuff is useful to others. Pm me your address if you want it.
|
01-13-2019, 11:17 PM | #29 |
Gone Wild
Join Date: Jun 2016
Posts: 647
|
Re: 2 stroke and 4 stroke differences / parts swapping
|
|
Thread Tools | |
Display Modes | |
|
Similar Threads | ||||
Thread | Forum | |||
4 Stroke Rearend for 1990 2 Stroke Cart | Gas EZGO | |||
87 Marathon 2 stroke parts | Gas EZGO | |||
1988 ezgo 2 stroke to 4 stroke questions | Big Block Talk! | |||
2 stroke parts id help | Gas EZGO | |||
Swapping an '83 2 stroke with a 4 stroke | Gas EZGO |