|
Gas EZGO Gas EZGO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
06-01-2020, 07:16 PM | #1 |
Not Yet Wild
Join Date: Jun 2016
Location: Pocono Summit, near Pocono Raceway
Posts: 60
|
carb help before I get out the c-4
I have an 88 marathon with the two stroke. I tried two carbs, the first one worked good for a couple weeks then started shooting gas out the vent. second carb (used, came with cart) worked for about 15 minutes, then started to do the same thing.
I bought a new carb, put it on and it will run if I keep it about half choke. (no choke, no vroom vroom) I checked the adjustment, tried it at 1 1/2 turns,, 2 turns,, and 2 1/2 turns still no put put without choke. Now I know I need exhaust gaskets, but before I toss money away I want to make sure this thing is gonna run. Any suggestions or ideas ???? |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
06-01-2020, 07:54 PM | #2 |
Test before replacing
Join Date: Aug 2013
Location: Ohio side of the Pennsylvania border.
Posts: 3,495
|
Re: carb help before I get out the c-4
I don't think you ever got a copy of the manual. it's down below.
Read page J-6. There is no adjustment on that carburetor. You can set the float level. That's it. |
06-02-2020, 06:35 AM | #3 |
Nincompoop village idiot
Join Date: Apr 2018
Location: Michigan
Posts: 9,673
|
Re: carb help before I get out the c-4
I'd suspect either a Reed problem or crank seals judging by your description.
|
06-03-2020, 03:16 PM | #4 |
Not Yet Wild
Join Date: Jun 2016
Location: Pocono Summit, near Pocono Raceway
Posts: 60
|
Re: carb help before I get out the c-4
No I didn't, but I do now. Thank you.
|
06-03-2020, 03:21 PM | #5 |
Not Yet Wild
Join Date: Jun 2016
Location: Pocono Summit, near Pocono Raceway
Posts: 60
|
Re: carb help before I get out the c-4
Have you guys ever heard of or seen where gas would shoot out of the vent on the carb before. I just think it's odd that it worked fine for awhile then started doing it. I"ve never had a carb do that unless the inlet needle and seat in the bowl was bad. But even them it only trickled out and this would actually shoot out.
|
06-03-2020, 08:12 PM | #6 |
Nincompoop village idiot
Join Date: Apr 2018
Location: Michigan
Posts: 9,673
|
Re: carb help before I get out the c-4
If you hold your hand over the carb when you crank it, does it suck your hand onto it?
Spray some carb cleaner around where the crankshaft seals are and see if it runs better. If so, definitely needs crank seals. Alao I'd pull the carb off and pull the reeds out and inspect them. If the reeds arent seating or chipped or anything it's not going to be a happy engine |
|
|
Similar Threads | ||||
Thread | Forum | |||
carb tuning mikuni or eBay CV carb | Clone Engine Swaps | |||
Carb rebuild kit for 97 Mikuni carb. | Gas Columbia ParCar | |||
1989 Ezgo New Carb leaking gas like the old Carb | Gas EZGO | |||
cheap carb swap onto 3PG engine- Tecumseh carb works great- with lots of pics | Gas EZGO | |||
91 2 Cycle Carb Missing Carb Screw | Gas EZGO |