1985 ezgo drunk disassemble

[Mkonrath72]

Hello I was drinking a few weeks back and took the carb off. But since the engine is in a Western body I couldn't reach the carb bolts so I just unbolted the 4 bolts on the(is it called a manifold) the thing that bolts where the reed valve goes. Anyways that part that I cant name has a hose on it. What does that hose go too? Does anyone have a service manual for 1985 as I also uns Reed this little fella and not sure about reinstall either. Thx..never disassemble while drinking.

[CP241]

If I'm looking st what I think I am, that's for the oil injection. I'd block it off with a bolt and some teflon tape and premix your gas.

Theres a few other guys on here much more familiar with those older 2T's than me, maybe theyll chime in

[Dabble Inn]

I'd also think you're asking about the oil injection line and fitting that's bolted to the intake manifold, it should go to a pump on the fan side that's driven by the crank. Then another line from the pump to the oil tank on the firewall, that is IF you choose to keep it. I mix my gas/oil like said above....

Not sure what I'm looking at in the second pic, a length of throttle or choke or Gov cable with the cable stop still on it??

Also, a new reed valve isn't available anymore so don't hurt the one you have.