|
Gas Yamaha Gas Yamaha Golf Cars; G1 through "The Drive" and U-Max Utility Vehicles |
|
Thread Tools | Display Modes |
11-29-2020, 05:10 PM | #11 |
Getting Wild
Join Date: Nov 2020
Location: Edgewater. FL
Posts: 113
|
Re: What speed @ what rpm?
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
11-29-2020, 11:54 PM | #12 |
Not Yet Wild
Join Date: Nov 2020
Location: Canyon lake, Texas
Posts: 18
|
Re: What speed @ what rpm?
On my driven clutch the plastic button is in contact with the slide when at rest. I don’t know much about this but it looks different than mine.
|
11-30-2020, 12:59 AM | #13 | |
Getting Wild
Join Date: Nov 2020
Location: Edgewater. FL
Posts: 113
|
Re: What speed @ what rpm?
Quote:
As for the plastic buttons contacting the opposite side, I have no experience with these either but it seems to be the only place they can connect. I have not seen them contact the few times I've been able to look at the clutches while running the cart. |
|
11-30-2020, 01:28 AM | #14 |
Getting Wild
Join Date: Nov 2020
Location: Edgewater. FL
Posts: 113
|
Re: What speed @ what rpm?
Tonight , while chatting with Slonomo about clutches, I started the cart in neutral and ran up the RPMs up to WOT for a few seconds and for the first time I noted the belt going all the way to the top of the primary clutch. It also sounded pretty smooth compared to some prior attempts to get the clutch to fully close. The only thing I've done is changed the governor spring tension and to add a pmp of Moly D grease to the primary and secondary clutches. Maybe they were extremely dry from sitting a couple years. I recorded a video and posted it on Youtube...
https://www.youtube.com/watch?v=mJAMoKmnTH8 UPDATE: Please excuse the terrible video recording, it was originally just to be used as a sound recording without video and when I noted the belt going to the top of the primary clutch, I saved the video to share. At the end I was trying to see what RPM the motor was turning but couldn't read my tiny tach due to poor lighting. I'm guessing it was close to 3900 RPM. Last edited by Jammy; 11-30-2020 at 01:32 AM.. Reason: Video notes... |
|
|
Similar Threads | ||||
Thread | Forum | |||
MCOR? Speed Sensor? Controller? Cart Runs at half speed. Advice, please. | Electric Club Car | |||
2013 G29 sputters at slow speed runs like a champ at higher speed | Gas Yamaha | |||
Loud noise and clicking at full speed on new high speed motor. | Electric EZGO | |||
1204 controller, half-speed forward full speed reverse | Electric EZGO | |||
1985 G1 Runs fine low speed , high speed run for a mile then fall on its face | Gas Yamaha |