|
Gas Yamaha Gas Yamaha Golf Cars; G1 through "The Drive" and U-Max Utility Vehicles |
|
Thread Tools | Display Modes |
03-25-2021, 11:11 AM | #1 |
Not Yet Wild
Join Date: Mar 2021
Posts: 2
|
Installing a rear seat on a 12.5 with a Curtis Cab... has anyone done this?
I will be headed to my house in florida in a few weeks and will be ordering a rear seat kit to be delivered. I have chosen the Steelen rear seat kit as of now since it appears to be a not cut/no drill install and open to suggestions if its a poor choice.
I have a 2012.5 G29 with a Curtis cab. I see rear seat install videos requiring the removal of the roof/canopy. Does anyone know if i need to still do this with a curtis cab installed? I have minimal tools at the house so i am trying to understand if i will need to gather some extras to hold up the roof/canopy if the cab itself doesnt and anything else i may need. trying not to disassemble the entire upper half of the cart and cab if i dont have to. appreciate any input you guys have. thank you |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
03-25-2021, 11:30 AM | #2 |
Not Yet Wild
Join Date: Mar 2021
Posts: 2
|
Re: Installing a rear seat on a 12.5 with a Curtis Cab... has anyone done this?
side note, talked to Steeling... you do need to drill the carts frame in the bag well. so now i am open to any suggested seat if there are recommendations.
|
|
|
Similar Threads | ||||
Thread | Forum | |||
Installing Curtis 1268 controller | Electric Club Car | |||
Installing Aluminum vs. Steel Rear Seat | Electric Club Car | |||
Installing Rear Flip Seat On 07 Drive (electric) | Electric Yamaha | |||
Installing rear seat question ??? | Electric EZGO | |||
Installing a rear seat is it difficult? | Gas EZGO |