02-25-2015, 11:59 PM | #11 |
Gone Wild
Join Date: Aug 2009
Location: Cedar Hill, Missouri
Posts: 290
|
Re: ezgo st 480 workhorse
Different plugs, new wire harness to oils with new diodes. Biggest problem exhaust was clogged pretty good. I beat on it and ran long wire brush through it man was it clogged. Took about 45 min to get it some what cleaned out. Running bout 13 mph but doesn't seem to have the power it should for a 16hp briggs. My g14 with 18 briggs will smoke it I beleive. But the biggest thing is we now know the briggs lives so on to more tuning any ideas. It still smokes but it had set for about 5 years when we got it. We have only actually drove it for about 5 min since gettingit going
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
01-06-2019, 06:13 PM | #12 |
Getting Wild
Join Date: Jun 2008
Location: A little South of Dallas
Posts: 112
|
Re: ezgo st 480 workhorse
Where are these shorting diodes located and how can i test them?
Last edited by leftex; 01-06-2019 at 06:21 PM.. Reason: additional info |
01-07-2019, 10:38 AM | #13 |
Gone Wild
Join Date: Aug 2009
Location: Cedar Hill, Missouri
Posts: 290
|
Re: ezgo st 480 workhorse
there are two wires that runs from each coil to where the wires run from under the housing. you will notice a small lump in each wire, that's them. we just replaced the harness. the motor needs rebuilt now and cant get him to do it
|
01-08-2019, 02:40 PM | #14 |
Getting Wild
Join Date: Jun 2008
Location: A little South of Dallas
Posts: 112
|
Re: ezgo st 480 workhorse
Where should I look for the wire that runs from under the housing? I thought that if I could find and disconnect it I could tell if bad diodes are really my problem before I remove the fan shroud.
Thanks, Wayne |
01-08-2019, 08:55 PM | #15 |
Gone Wild
Join Date: Aug 2009
Location: Cedar Hill, Missouri
Posts: 290
|
Re: ezgo st 480 workhorse
If u just unplug it the cylinders interfere with each other n will run terrible.
|
01-08-2019, 08:58 PM | #16 |
Getting Wild
Join Date: Jun 2008
Location: A little South of Dallas
Posts: 112
|
Re: ezgo st 480 workhorse
So you are saying I have to remove the wires from the coils in order to see if the diodes are my problem?
|
01-08-2019, 09:58 PM | #17 |
Gone Wild
Join Date: Aug 2009
Location: Cedar Hill, Missouri
Posts: 290
|
Re: ezgo st 480 workhorse
Mine didn't have the harness. You have to have the diodes tested.
|
01-08-2019, 10:23 PM | #18 |
Nincompoop village idiot
Join Date: Apr 2018
Location: Michigan
Posts: 9,683
|
Re: ezgo st 480 workhorse
Cut the tape, remove the diodes and just test them. It only takes a few seconds to unplug it and test it. Moat meters have a diode test function. It will beep one way but not if you switch the leads to the opposite side of the diode.
https://www.fluke.com/en-us/learn/be...tal-multimeter |
01-08-2019, 10:30 PM | #19 |
Gone Wild
Join Date: Mar 2015
Location: Central mn
Posts: 1,036
|
Re: ezgo st 480 workhorse
Just a shot here but if the muffler is, was that clogged you should burn it out.
Start a fire and chuck it in their for a hour or two. |
|
|
Similar Threads | ||||
Thread | Forum | |||
EZGO workhorse | Gas EZGO | |||
EZGO workhorse vs. Regular EZGO golf cart | Gas EZGO | |||
96 ezgo workhorse | Golf Carts and Parts | |||
EZGO workhorse | Gas EZGO | |||
EZGO Workhorse 6 PASSENGER limo Setup for Briggs,Honda or Ezgo Motor | Golf Carts and Parts |