02-21-2011, 06:25 AM | #1 |
Getting Wild
Join Date: Sep 2010
Location: Warrenton, Virginia
Posts: 98
|
Accelerator micro switch?
OK....on a 84 gas CC....I had to put a new accelerator micro-switch on because the cold temps. cracked the plastic and broke the old one. Here's my question. How does the open /close circuit work on it with it being open when you apply the brake...(thus shutting engine off) and also being open when you apply the accelerator pedal about half way? Am I adjusting it wrong?
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
02-22-2011, 07:28 PM | #2 |
Gone Wild
Join Date: Aug 2010
Location: North Dakota
Posts: 196
|
Re: Accelerator micro switch?
What switch did you replace the starter switch or the kill switch? They should both close (the arm should press in) when the accelerator is pressed and not open until it is released. You have to make sure the wires are connected to the proper terminal. There is a normally open and a normally closed terminal.
|
|
Thread Tools | |
Display Modes | |
|
Similar Threads | ||||
Thread | Forum | |||
Micro switch on fwd and rev switch has bee removed | Electric EZGO | |||
Micro Switch or Solenoid | Electric Club Car | |||
Contiuity on accelerator micro | Electric EZGO | |||
Can The Micro Switch Short Out? | Gas Yamaha | |||
micro switch | Electric EZGO |