|
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
05-26-2013, 10:31 AM | #1 |
Not Yet Wild
Join Date: May 2013
Location: Central Florida
Posts: 5
|
Will not move in either forward or reverse
I have a 94 Marathon. It will not move either forward or reverse. The batteries are charged. The F/R switch was replaced before I received the cart so I'm wondering if there is a bad connection there someplace. I do not know a lot about electrical systems but would love to learn so that I can fix up my cart. Any suggestions would be appreciated. Oh yes, there's two wires, one black and the other red, that are on the forward side of the switch that aren't connected to anything, I'm assuming those are ground wires but not sure. They are very small in diameter. Not sure if that matters or not.
Last edited by CeaBurd; 05-26-2013 at 12:14 PM.. Reason: Corrected the wire colors from red to black |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
05-27-2013, 12:35 PM | #2 |
Not Yet Wild
Join Date: May 2013
Location: Central Florida
Posts: 5
|
Re: Will not move in either forward or reverse
I posted the question way too soon. I was getting frustrated and wanted a quick fix. I failed to mention the events leading up to the cart completely stopping. A couple of weeks ago the cart started hesitating when I would try to go in reverse. It would do it in forward also but seemed to do it in reverse most of the time. Now it will not go at all. As I mentioned before I am a newbie here, I want to restore my cart a little at a time, as finances will allow. I know I will be able to pick up a lot of knowledge on this site. Thanks.
|
05-27-2013, 03:19 PM | #3 |
Not Yet Wild
Join Date: Apr 2013
Location: TEXAS
Posts: 14
|
Re: Will not move in either forward or reverse
you should search for the wiring diagram specific to your model and verify all wiring first, if you have loose wires they need to go someplace and until you get the wiring sorted you will never know what the true problem is or if you even have a problem other than miswired components.
|
05-30-2013, 08:11 AM | #4 |
Not Yet Wild
Join Date: May 2013
Location: Central Florida
Posts: 5
|
Re: Will not move in either forward or reverse
Thank you Restoredude. I did just that and I did not see those wires anywhere on the diagram. Apparently the person who had the cart previous to me added on some things and those were wires that he added himself. I have since found out that I have one bad battery that is probably the cause of the problem. It is only reading 5 volts. I have been advised to get a used battery to take it's place because I am going to be restoring the cart this fall and I need something just to get me through the summer. I will be putting all new batteries and cables on at that time.
|
05-30-2013, 09:02 AM | #5 |
Happy Carting
Join Date: Dec 2007
Location: Southern California
Posts: 73,358
|
Re: Will not move in either forward or reverse
This diagram should fit your cart.
|
06-03-2013, 08:12 AM | #6 |
Not Yet Wild
Join Date: May 2013
Location: Central Florida
Posts: 5
|
Re: Will not move in either forward or reverse
Thank you Scottyb..that is the best one I've seen yet.
|
06-03-2013, 08:50 AM | #7 |
Happy Carting
Join Date: Dec 2007
Location: Southern California
Posts: 73,358
|
Re: Will not move in either forward or reverse
Once you confirm the wiring and cables are run correctly. confirm the solenoid is clicking when you try to go. If the cart moves in one direction but not the other or operation is spuratic, The F&R switch may be faulty.
|
04-04-2015, 08:55 PM | #8 |
Not Yet Wild
Join Date: Apr 2015
Posts: 51
|
Re: Will not move in either forward or reverse
New to the forum, and carting for that matter, and refreshing an old post that pertains to me. 92 marathon controller cart is dead in the water. Took it off charge and hit the gas to back out of garage; it jumped initially and then nothing. Now just clicks when accelerator is pressed in forward and reverse. I will add that it had similar symptoms a week or two prior - would run but if accelerator was fully pressed it would cut out. Fingered over some of the readily visible connections and problem solved... until now. Will go through and check all connections and wiring first- any other suggestions at this point though? Thanks much!
|
|
Thread Tools | |
Display Modes | |
|
Similar Threads | ||||
Thread | Forum | |||
move the forward/reverse switch | Electric Club Car | |||
Cart won't move forward or reverse | Gas Club Car | |||
Runs/starts - won't move - forward or reverse | Gas Club Car | |||
Can I move the forward/reverse switch? | Electric EZGO | |||
'92 CC will move in reverse, but, no forward... | Electric Club Car |