|
Electric Club Car Electric DS, and Precedent golf cars |
|
Thread Tools | Display Modes |
07-09-2017, 01:55 PM | #1 |
Getting Wild
Join Date: Oct 2016
Location: Gleniffer Lake Resort ALBERTA Canada
Posts: 119
|
1999 Clubcar DS motor instal
I pulled ot a 48 volt motor from this cart because it was building up bad vibration and made noise when going above 4 mph.It also would slow down like the batteries were dieing then if you hit a bump it would pick up again.
What I found inside was lots of carbon dust and a nose bearing that felt dry with a bit of play.l have replaced the bearing and checked the rotor assembly all is good and the brushes are like new. My question is what type of lubricant should l use on the output splines ,and the was no bumper inside the output shaft does it require on to help eliminate vibrations I went on the Clubcar web site and couldn't locate this particular information |
|
|
Similar Threads | ||||
Thread | Forum | |||
Precedent stereo instal | Electric Club Car | |||
Stereo instal | Electric Club Car | |||
instal clone motor | Gas Yamaha | |||
Should I instal a govenor? | Gas Harley Davidson | |||
1999 48V clubcar | Electric Club Car |