|
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
05-29-2012, 10:35 PM | #1 |
Not Yet Wild
Join Date: Jan 2012
Location: GA
Posts: 12
|
Can't get new Alltrax DCX500 and motor working....HELP!!!!
I have a 2001 EzGo PDS and the contoller / motor went out not long ago. I ordered a new EY7-4001 motor, DCX500, 3amp diode, resister, fuse, 2awg cables, 400 amp Solenoid w/ bracket.
I installed all of the above according to the wiring diagram and get nothing out of the DCX. No green LED or nothing. I went over and over the diagram, checked my diode to make sure the white stripe was facing the postive connector that connects to battery. I connected the small red wire to the positive connection on the Solenoid that runs to the battery. The yellow wire is connected to the #1 position on the solenoid, and blue is connected to #2 position. I am not sure where all to check for voltage. I have 38-40vdc passing thru the solenoid. I am wondering if my wiring harness got damaged when the controller melted? Also my volt meter does not come on either. I can get some pics if needed. I am also planning on calling EV Drives since I ordered them from there and see if they can help. After that I will call Alltrax. Just wondered if anyone knew where to test first. Thanks Brian |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
|
Similar Threads | ||||
Thread | Forum | |||
Alltrax DCX500 | Electric EZGO | |||
Alltrax DCX500 w/ D&D 502:2 Programming Question | Electric Club Car | |||
Alltrax DCX500 Install | Electric EZGO | |||
Alltrax DCX500 diagnostic issue | Electric EZGO | |||
alltrax dcx500 | Golf Carts and Parts |