|
|
|||||||
| Electric Club Car Electric DS, and Precedent golf cars |
  |
|
|
Thread Tools | Display Modes |
09-14-2015, 08:33 PM
|
#1 |
|
Not Yet Wild
Join Date: Sep 2015
Posts: 3
|
New alltrax controller, new motor and noid, no go
04 ds club car. Just installed dcx500 alltrax controller, 500 amp d&d motor, sw180 solenoid and 4ga wires. Drove the cart in the shop, was 100% stock. Switched out the parts above and now it won't run. The solenoid will not close, reset obc, no change, controller blinks 6 red, which says undervoltage, charged all night, pack reads 52v, new wire does pass thru obc. Batteries are US replacements about 1-1/2 yrs old. At a loss. Thanks for the help.
|
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
09-14-2015, 08:40 PM
|
#2 |
|
Not Yet Wild
Join Date: Apr 2014
Location: Midwest
Posts: 60
|
Re: New alltrax controller, new motor and noid, no go
I had similar problem - it was the solenoid.
ScottyB has nice write up on solenoids and why they may fail. It's a sticky post. I'd check your voltage at the controller and compare to pack voltage. - give the solenoid a tap also...that's how I got mine out of the woods and home after I installed new controller- just my two cents. There is a LOT smarter guys than me who I sure will offer their thoughts! Good luck.  Last edited by AWandKW; 09-14-2015 at 08:41 PM.. Reason: Spellin |
|
|
|
|
09-14-2015, 08:53 PM
|
#3 |
|
Not Yet Wild
Join Date: Sep 2015
Posts: 3
|
Re: New alltrax controller, new motor and noid, no go
Tapped on the noid no change, put the stock noid on and same thing. No go.
|
|
|
|
|
09-14-2015, 09:37 PM
|
#4 |
|
Not Yet Wild
Join Date: Apr 2014
Location: Midwest
Posts: 60
|
Re: New alltrax controller, new motor and noid, no go
Have you tried to bypass the solenoid? And did you check your voltage at the controller?
|
|
|
|
|
09-15-2015, 09:33 PM
|
#5 |
|
Not Yet Wild
Join Date: Sep 2015
Posts: 3
|
Re: New alltrax controller, new motor and noid, no go
Figured it out, power wire to the switch was on the wrong side of the solenoid.
|
|
|
|
|
|
||||||
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| D&d motor selection with alltrax 500 amp controller | Electric EZGO | |||
| NEW- Alltrax SPM-48400 Motor Controller | Golf Carts and Parts | |||
| 300 Amp alltrax controller/ stock motor | Electric EZGO | |||
| Alltrax DCX 500 Controller, D&D torque Motor | Golf Carts and Parts | |||
| 500 amp alltrax controller on stock motor? | Electric EZGO | |||
Linear Mode
